Bedienungsanleitung Viessmann Vitotronic 200 - CO1E (Seite 10 von 60) (Englisch)

813832

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

The Vitotronic 200, type CO1E and type CO1I control

units are designed for weather-compensated control of

single boiler systems.

The Vitotronic control unit is factory-configured as

"Single boiler weather-compensated".

In weather-compensated mode, the flow temperature

level is controlled according to the outside tempera-

ture. The lower the outside temperature, the higher the

flow temperature. This means that more heat is provi-

ded for central heating and DHW heating on cold days

than on warmer days.

Note

Alternatively, your contractor can configure the

Vitotronic 200 for one of the following application

areas:

■"Single boiler constant control"

This makes the Vitotronic control unit suitable for

control of a single boiler system with constant boiler

water temperature.

You can find all information on operation in the

"Vitotronic 100" operating instructions.

■"Boiler in the Cascade"

The Vitotronic control unit is then used to control the

boiler water temperature of a boiler in a multi boiler

system.

You can find all information on operation in the

"Vitotronic 300" or "Vitotronic 100" operating instruc-

tions.

Commissioning

The commissioning and matching of the control unit to

local conditions and building characteristics, as well as

instructing the user in the operation of the system,

must be carried out by your contractor.

As the user of new combustion equipment, you may be

obliged to notify your local flue gas inspector of the

installation [check local regulations]. Your local flue gas

inspector [where applicable] will also provide you with

information on additional activities concerning your

combustion equipment (such as regular testing, clean-

ing, etc.).

Your system is preset

Your heating system is preset at the factory and is

therefore ready for operation following commissioning

by your contractor:

Central heating

■Between 06:00 h and 22:00 h, rooms are heated to

20 °C "Room set temperature" (standard room

temperature).

■Between 22:00 h and 06:00 h, rooms are heated to

3 °C "Set reduced room temperature" (reduced

room temperature, frost protection).

DHW heating

■Between 05:30 and 22:00 h, the DHW is heated to a

50 °C "DHW set temperature". Any installed DHW

circulation pump is switched on.

■Between 22:00 and 05:30 h, the DHW cylinder is not

reheated. Any installed DHW circulation pump is

switched off.

Note

Any DHW heating begun before 22:00 h is termina-

ted.

Frost protection

■Your boiler and DHW cylinder are protected against

frost.

Wintertime/summertime changeover

■This changeover is automatic.

Date and time

■The date and time were set by your heating contrac-

tor.

You can change the settings at any time to suit your

individual requirements.

Power failure

All settings are saved if there is a power failure.

Introductory information

Product information

5863724

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Viessmann Vitotronic 200 - CO1E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Viessmann Vitotronic 200 - CO1E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info