11
0478 105 9821 K - EN
SV
NO EN
DA
FIPL
HU
Cleaning the
appliance
Maintenance interval:
Each time the appliance is
used
Clean the appliance
thoroughly after mowing.
Looking after your appliance
carefully will protect it against
damage and extend its
service life.
Clean the underside of the
mower with water and a
brush. Detach accumulated
cutting deposits in the
housing and in the ejection
chute beforehand using a
stick.
Never spray water onto
engine components, seals,
bearing points or electrical
parts such as switches. This
would result in expensive
repairs.
Please note:
Tilt up front of mower when
carrying out cleaning or
maintenance work.
Empty the fuel tank (run
empty), release the rotary
knobs and lift the ejection
flap before tilting upwards.
23
Maintenance
Disconnect the spark
plug socket before
performing any
maintenance or other
work on the blade.
Do not touch the blade until it
has come to a standstill.
Always allow the engine to
cool before carrying out
maintenance and cleaning
work.
Risk of injury.
Always wear gloves.
If you do not have the
necessary auxiliary
equipment, your dealer will
be pleased to assist you.
In the interests of safety, only
use original VIKING spare
parts.
CAUTION
Emptying the grass
catcher bag
If
F= level indicator closes
(STOP position), the
grass catcher bag is full
and must be emptied.
Detach the grass catcher
bag and open it at
22= tab. Fold
7= grass catcher bag upper
part upwards.
Fold back the full grass
catcher bag.
The grass catcher bag
can be emptied easily via
the
23= integrated handle.
After emptying, close the
upper part and lock back
into position.
22
Single-speed wheel
drive MB 455 E/ M/ C/ BC
Pull
E= drive lever:
The mower's wheel drive
engages.
Release the drive lever:
The mower's wheel drive
is disengaged.
21
NOTE
Please observe the
illustrations on the level
indicator.
Stopping the blade/
engine MB 455 BC
Stopping the blade:
To stop the blade,
release
A= blade stop lever. The
blade is disengaged and
brought to a standstill in
a few seconds by means
of a brake.
The engine continues
running after the blade
stop lever has been
released.
Stopping the engine:
To stop the engine, set
D= acceleration lever to the
STOP position.
20
