667312
57
Zoom out
Zoom in
Vorherige Seite
1/376
Nächste Seite
0478 111 9918 E - EN
17
DE
FR
ENNL
IT
ESPT
NO
SVFIDAPL
26
Mowing blade
maintenance
The adjustment must be
repeated (if necessary,
contact a specialist dealer;
VIKING recommends VIKING
specialist dealers).
CAUTION
Risk of injury!
If, when pulling back, the
driving wheels are locked
when the drive lever is not
actuated, the cable is
adjusted incorrectly and the
mower drive is permanently
activated.
CAUTION
Risk of injury!
If you do not have the
necessary expertise or
auxiliary equipment, please
always contact a specialist
dealer. (VIKING
recommends VIKING
specialist dealers).
VIKING recommends the
use of original VIKING
tools, accessories and
spare parts.
NOTE
Lilt the front of the mower
upwards when carrying out
cleaning or maintenance
work. Before tilting upwards,
empty the fuel tank, detach
the grass catcher bag, fold
down the upper handlebar
(see section “Assembling
the handlebar”) and lift the
ejection flap.
Wheels and gearbox
The ball bearings of the
wheels are maintenance-free.
The vario gearbox and the
three-speed gearbox are
maintenance-free.
Never spray water on engine
components, seals or bearing
points. This may result in
damage and expensive
repairs.
Do not use aggressive
cleaning agents. These
cleaners can damage plastics
and metals, impairing safe
operation of your VIKING
mower.
If you are unable to remove
the dirt with water, using a
brush or a cloth, VIKING
recommends the use of a
special cleaner (e.g. STIHL
special cleaner).
Maintenance interval:
As required (wheel drive does
not engage when the wheel
drive lever is actuated)
The tension of the cable is
adjusted correctly at the
factory. However, the cable
may have to be adjusted
again following an extended
period of use.
The adjustment is made
using an
24= adjustment screw located
on the upper handlebar.
25
Adjusting the wheel
drive cable
Correct adjustment:
The driving wheels must lock
after approx. one third of the
lever travel.
Actuate the drive lever while
pulling the lawn mower
backwards.
The cable tension is
increased by turning the
24= adjustment screw in the
"+" direction, turning it in
the "-" direction reduces
the tension.
CAUTION
Risk of injury!
If the wheel drive cable is
incorrectly adjusted, the
mower may start to move
unintentionally immediately
when started and this may
result in injury or damage to
the appliance.
CAUTION
Risk of injury!
Before tilting upwards, place
the mower on firm,
horizontal and level ground
and adjust it to the highest
cutting level (level 7),
otherwise the mower might
tilt forwards again.
Maintenance interval:
Before each use
Tilt the mower upwards into
the cleaning position.
Clean the mowing blades
and all fastening elements
(retaining washer, blade
fastening screws, guard
plate), check for damage
(notches, cracks or
deformation) and wear
and replace if necessary.
27
57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Viking MB 655G wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info