Bedienungsanleitung Viking MT 6127ZL (Seite 46 von 290) (Englisch, Portugiesisch, Spanisch)

667338

Zoom out

Zoom in

Vorherige Seite

1/290

Nächste Seite

0478 192 9807 C - EN

– Observe the instructions on cleaning

the engine (see engine instruction

manual).

– Remove grass residues from the

gearbox (by brushing off), remove any

other dirt from the gearbox.

– Check the cooling ribs of the engine

and hydrostatic gearbox and clean if

necessary.

Maintenance operations after the first

10 operating hours (initial operation):

– An inspection by your specialist dealer

is recommended.

VIKING recommends

VIKING specialist dealers.

Maintenance operations after every

25 operating hours:

– Check the blade fastenings and

mowing blade wear limits.

– Check the installation position of the

mowing blades (MT 5112 Z,

MT 6112 C, MT 6112 ZL, MT 6127 ZL).

Maintenance operations after every 50

operating hours:

– Check the installation position of the

mowing deck. (Ö 15.14)

Maintenance operations after every 100

operating hours:

– Replace the mowing blades.

– Maintain the V-belt or toothed belt.

– Inspection by a specialist dealer.

VIKING recommends VIKING specialist

dealers.

15.2 Cleaning the machine

● Stop the engine. (Ö 13.3)

● Engage the parking brake. (Ö 8.14)

● Remove the ignition key and keep it in a

safe place.

● Remove the mowing deck. (Ö 14.1)

● First, remove accumulated clipping

deposits in the mowing deck housing

using a stick.

● Clean the underside of the mowing

deck with water and a brush.

● When cleaning the upper side of the

mowing deck, ensure that the V-belt

and toothed belt do not get wet – never

spray water into the openings in the

covers.

● Clean the discharge chute using

running water and a brush when

removed and well away from the

machine.

● Remove grass residues from the

mowing deck, the engine compartment

and the gearbox. Clean the cooling ribs

of the engine and gearbox.

● Clean the mowing blades with water

and a brush – under no circumstances

should you hit the mowing blades (e.g.

with a hammer) to loosen dirt.

● Remove the grass catcher box and

clean using running water and a brush

well away from the machine. (Ö 13.10)

15.3 Opening the engine hood

Hold the engine hood (1) with one hand at

the handle (2) and open by pulling gently

upwards.

Fold the engine hood (1) forwards to the

stop.

All required maintenance

operations on the brake system and

gearbox are carried out during the

inspection.

Avoid damage to the machine.

Never spray water (high pressure

cleaner) onto engine components,

seals, electrical components

(battery, wiring harness, etc.) and

bearing points. This may result in

damage and expensive repairs.

Do not use aggressive cleaning

agents. These cleaners can

damage plastics and metals,

impairing the safe operation of your

VIKING machine. If you are unable

to remove the dirt with water using

a brush or a cloth, VIKING

recommends the use of a special

cleaner (e.g. STIHL special

cleaner).

Always remove the mowing deck

for cleaning and maintenance

operations.

Danger of burns!

Allow the engine to cool down

before opening the engine hood.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Viking MT 6127ZL Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Viking MT 6127ZL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info