536360
24
Zoom out
Zoom in
Vorherige Seite
1/29
Nächste Seite
53
CyCy NiMH
Maximum cycle count for NiMH batteries in the “Cycle” function; variable in the range 2 to 20 cycles
CyFo NC
Maximum cycle count for NC batteries in the “Form” function; variable in the range 2 to 20 cycles
CyFo NiMH
Maximum cycle count for NiMH batteries in the “Form” function; variable in the range 2 to 20 cycles
Restore
If you select “Restore” and confirm it by pressing the “OK / Menu” button, all charge / discharge
parameters are returned to the standard default values.
Return
“Setup ALC” is a further sub-menu within the configuration menu of the ALC 8500-2 Expert. Confirm
your selection with the “OK / Menu” button, and the menu points shown in Fig. 30 are available.
14.3 Setup ALC
“Setup ALC” is a further sub-menu within the ALC 8500-2 Expert’s Configuration menu. Confirm your
selection with the “OK / Menu” button, and the menu points listed in Fig. 30 are available:
Fig. 30: Menu points in the “Setup ALC” menu
14.3.1 Illuminat.
In this menu (Fig. 31) you can set the duration of the display backlighting in active mode after the last
operation of the controls (buttons, jog dial). The times available are: 1
minute, 5 minutes, 10 minutes, 30 minutes and 60 minutes. It is also
possible to switch the backlighting on or off permanently.
14.3.2 Contrast
Calling up this menu enables you to set the screen contrast to any of
sixteen values, and store your preference (see Fig. 32).
14.3.3 Al. Beep
The ALC 8500-2 Expert is fitted with an audible sounder which emits
various alarm signals if limit values are exceeded, if an error occurs
and after the conclusion of various functions. At this menu point you
can switch the sounder function on and off.
14.3.4 But. Beep
When the “Button Beep” function is active, the charger emits a brief
audible beep every time you press a button or turn the jog dial (incre-
mental control).
Fig. 31: Setting the time for
screen backlighting
Fig. 32: Setting the screen
contrast
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

voltcraft-alc-8500-expert

Suche zurücksetzen

  • Bei Ladeschlußspannung automatische abschaltung ja oder nein Eingereicht am 6-4-2018 08:55

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Voltcraft ALC 8500 EXPERT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Voltcraft ALC 8500 EXPERT

Voltcraft ALC 8500 EXPERT Bedienungsanleitung - Deutsch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info