36
Please always observe the safety instructions!
Error Possible cause Remedy
The device Is the battery dead? Check the status.
does not work. Battery replacement
None change of the Is a wrong measuring function Check the display (AC/DC) and
measuring value. activated (AC/DC)? switch the function if applicable.
Is the HOLD function activated? Press the key “HOLD” to
(display “HOLD”) deactivate this function.
Repairs other than those described should only be carried out by an authorised
specialist. If you have queries about handling the measuring device, our technical
support is available under the following telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15, Tel.-No. 0180 / 586,582 7.
TECHNICAL DATA
Display
LCD; 2000 counts
Measuring cable length about 80 cm each
Measuring impedance >7.5 MΩ (V range)
Automatic switch-off approx. 15 minutes
Operating voltage DMM 2 x micro batteries (AAA)
Receiver 9V block battery
Transmitter 9V block battery
Working conditions 0 to 40°C (<75%rh)
Operating altitude max. 2,000 m
Storage temperature -10°C to +50°C (<80%rh)
Weight DMM ca. 308 g
Transmitter ca. 230 g
Dimensions (LxWxH) DMM 162 x 74 x 44 (mm)
Transmitter 140 x 69 x 32 (mm)
Over-voltage category CAT III 600 V, contamination degree 2
(only DMM via safety sockets)
Line allocation
Conductor resistance max. 30 kΩ (for test length)
Polarity test 5 – 16 V/DC
Continuity tester <100 Ω (acoustic)
Measuring cable length about 27 cm each
Overload protection max. 50 V
