Bedienungsanleitung Voltcraft VC-450 E (Seite 41 von 136) (Deutsch, Englisch, Holländisch, Französisch)

738231

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

6. Safety notes

Read the operating instructions attentively and particularly observe the safety notes. If the safety

notes and the information in these operating instructions regarding proper handling are not ob-

served, we assume no liability for any resulting injury/property damage. In such cases, the war-

ranty/guarantee will also lapse.

• Forsafetyandapprovalreasons, unauthorisedconversionand/or modicationof thedeviceare not

permitted.

• Consult an expert when in doubt as to the operation, safety or the connection of the device.

• Meters and accessories are not toys and have no place in the hands of children!

• In commercial institutions, the accident prevention regulations of the Employer’s Liability Insurance As-

sociation for Electrical Systems and Operating Materials are to be observed.

• In schools, training centres, computer and self-help workshops, handling of meters must be supervised

by trained personnel in a responsible manner.

• Ensure before every measurement that the meter is set to the proper measuring function.

• When using the measuring prods without cover caps, measurements between the meter and the earth

potential must not be performed above the measuring category CAT II.

• When measuring in the measuring category CAT III and CAT IV, measuring prods with cover caps (max.

4 mm free contact length) must be used to avoid accidental short circuits during measurement. They are

enclosed.

• The measuring prods have to be removed from the measured object every time the measuring function

is changed.

• The voltage between the connection points of the meter and the earth potential must not exceed

1000 V DC/AC in CAT III or 600 V DC/AC in CAT IV.

• Be especially careful when dealing with voltages higher than 33 V alternating (AC) or 70 V direct volt-

age (DC)! Even at these voltages it is possible to receive a potentially fatal electric shock if you touch

electrical conductors.

• To avoid electric shock, make sure not to touch the connections/measuring points to be measured di-

rectly or indirectly during measurement. During measuring, do not grip beyond the tangible grip range

markings present on the measuring prods.

• Check the meter and its measuring lines for damage before each measurement. Never carry out any

measurements if the protecting insulation is defective (torn, ripped off etc.). The enclosed measuring

cables have a wear indicator. When they are damaged, a second insulation layer in a different colour

becomes visible. The measuring accessories must no longer be used and must be replaced.

• Do not use the multimeter just before, during or just after a thunderstorm (lightning! / high-energy over-

voltage!).Makesurethatyourhands,shoes,clothing,theoor,circuitsandcircuitcomponentsaredry.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Voltcraft VC-450 E Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info