43
Error Possible cause Remedy
The multimeter Is the battery dead? Check the status.
does not work.
No measuring The HOLD function is activated Press the button "HOLD" again.
change. (display shows "H") The symbol "H" disappears.
Is the wrong measuring function Check the display (AC/DC) and
active (AC/DC)? switch the function if applicable.
Did you use the wrong measuring Check the measuring sockets.
sockets?
Is the fuse defect? In A/mA/µA range: Change the
fuse as described in the chapter
"Changing the fuse".
ƽ
Repairs other than those described should only be carried out by an authorised specialist.
If you have queries about handling the measuring device, our technical support is available
under the following telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15, phone 0180 / 586 582 7
Technical data
Display ........................................................2000 counts (4000 counts with the VC170)
Measuring frequency ..................................approx. 2-3 measuring operations/second
Measuring lead length ................................about 75 cm each
Measuring impedance ................................>10MΩ (V range)
Operating voltage........................................9V block battery
Working temperature ..................................0°C to 40°C
Operating altitude........................................max. 2,000 m
Storage temperature....................................-10°C to +50°C
Weight ........................................................ca. 200 g
Dimensions (LxWxH) ..................................137 x 72 x 35 (mm)
Over-voltage category ................................CATIII 250 V
Measurement tolerances
Statement of accuracy in ± (% of reading + display error in counts (= number of smallest points)). The
accuracy is valid for one year at a temperature of +23°C ± 5°C, and at a relative humidity of less than
75%, non-condensing.
