Bedienungsanleitung Voltcraft VC165 (Seite 31 von 96) (Deutsch, Englisch, Holländisch, Französisch)

738218

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

When using the measuring lines without cover caps, measurements between the meter and

the earth potential must not be performed above the measuring category CAT II.

When measuring in the measuring category CAT III, the cover caps must be pushed onto the

measuring prods to avoid accidental short circuits during measurement.

Push the cover caps onto the measuring prods until they latch. To remove, pull the caps from

the prods with a little force.

The measuring prods have to be removed from the measured object every time the measuring range is changed.

The voltage between the connection points of the meter and earth potential must not exceed 600 V DC/AC in

CAT III.

Be especially careful when dealing with voltages higher than 33 V alternating (AC) or 70 V direct voltage (DC)! Even

at these voltages it is possible to receive a potentially fatal electric shock if you touch electrical conductors.

To avoid electric shock, make sure not to touch the connections/measuring points to be measured directly or

indirectly during measurement. Never reach beyond the noticeable grip area marks at the measuring prods during

measurements.

Check the meter and its measuring lines for damage before each measurement. Never carry out any measurements

if the protecting insulation is defective (torn, ripped off etc.). The enclosed measuring cables have a wear indicator.

When they are damaged, a second insulation layer in a different colour becomes visible. The measuring accessories

must no longer be used and must be replaced.

Do not use the multimeter just before, during or just after a thunderstorm (lightning! / high-energy overvoltage!).

Make sure that your hands, shoes, clothing, the oor, circuits and circuit components are dry.

Never operate the product in direct proximity of:

- strong magnetic or electromagnetic elds

- Transmitter aerials or HF generators.

This could affect the measurement.

If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make

sure it is not operated unintentionally. It can be assumed that safe operation is no longer possible if:

- the device shows visible damage

- the device no longer functions

- the device was stored under unfavourable conditions over an extended period of time or

- following considerable stress during transportation.

Do not switch the meter on immediately after it was taken from a cold to a warm environment. The condensation

that forms might destroy your device. Allow the device to reach room temperature before switching it on.

Do not leave the packaging material lying around carelessly since such materials can become dangerous toys in the

hands of children.

Also observe the safety information in each chapter of these instructions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Voltcraft VC165 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info