Bedienungsanleitung Volvo C70 - 2008 (Seite 70 von 246) (Englisch)

484375

Zoom out

Zoom in

Vorherige Seite

1/246

Nächste Seite

hold the desired HomeLink button while you press and re-press ("cycle") your handheld transmitter every two seconds

until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds

upon successful training. DO NOT release until the HomeLink indicator light flashes slowly and then rapidly. When

the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful training.)

02 Instruments and controls

HomeLink® Universal Transceiver (option)

4. Press and hold the trained HomeLink button and observe the indicator light.

If the indicator light is solid/continuous, training is complete and your device should activate when the HomeLink

button is pressed and released.

If the indicator light blinks rapidly for 2 seconds and then turns a solid/continuous light, proceed with the following

training instructions for a rolling code device. A second person may make the following steps quicker and easier.

Please use a ladder or other device. Do not stand on your vehicle to perform the next steps.

5. At the garage door opener receiver (motorhead unit) in the garage, locate the "learn" or "smart" button (usually near

where the hanging antenna wire is attached to the unit). If there is difficulty locating the training button reference the

garage door opener's manual or contact us.

6. Press and release the "learn" or "smart" button (the name and color of the button may vary by manufacturer).

NOTE

Once the button is pressed, there are 30 seconds in which to initiate the next step.

7. Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat

the "press/hold/release" sequence up to 3 times to complete the training process.

NOTE

During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold

the desired HomeLink button while you press and repress ("cycle") your hand-held transmitter every two seconds

until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several

seconds upon successful training. If necessary, follow steps 5-7 to complete the training for a rolling code device.

To train additional HomeLink buttons, begin with step two.

Rolling Code Programming

Rolling code garage door openers that are "code-protected" and manufactured after 1996 may be determined by the-

following:

Reference the garage door opener owner's manual for verification.

The handheld transmitter appears to program the HomeLink Universal Transceiver but does not activate the garage

door.

Press and hold the trained HomeLink button. The garage door opener has the rolling code feature if the indicator

light flashes rapidly and then turns solid after 2 seconds.

To train a garage door with the rolling code feature, follow these instructions (the aid of a second person may make the

training quicker and easier):

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Volvo C70 - 2008 Seite 70

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Volvo C70 - 2008

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info