Bedienungsanleitung Vonroc S3-CD509DC (Seite 5 von 78) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch, Schwedisch)

763970

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

WWW.VONROC.COM

ﬁre, explosion or risk of injury.

f) Do not expose a battery pack or tool to ﬁre

or excessive temperature. Exposure to ﬁre or

temperature above 130 °C may cause explo-

sion. NOTE The temperature „130 °C“ can be

replaced by the temperature „265 °F“.

g) Follow all charging instructions and do not

charge the battery pack or tool outside the

temperature range speciﬁed in the instructi-

ons. Charging improperly or at temperatures

outside the speciﬁed range may damage the

battery and increase the risk of ﬁre.

6) Service

a) Have your power tool serviced by a qualiﬁed

repair person using only identical replacement

parts. This will ensure that the safety of the

power tool is maintained.

Never service damaged battery packs. Service

of battery packs should only be performed by the

manufacturer or authorized service providers.

ADDITIONAL SAFETY WARNINGS FOR DRILLS

AND SCREW DRIVERS

Drill safety warnings

a) Wear ear protectors when impact drilling.

Exposure to noise can cause hearing loss.

b) Hold the power tool by insulated gripping surfa-

ces, when performing an operation where the

cutting accessory may contact hidden wiring.

Cutting accessory contacting a “live” wire may

make exposed metal parts of the power tool

“live” and could give the operator an electric

shock.

c) Brace the tool properly before use. This tool

produces a high output torque and without

properly bracing the tool during operation, loss

of control may occur resulting in personal injury.

SAFETY INSTRUCTIONS WHEN USING LONG

DRILL BITS

a) Never operate at higher speed than the maxi-

mum speed rating of the drill bit. At higher

speeds, the bit is likely to bend if allowed to

rotate freely without contacting the workpiece,

resulting in personal injury.

b) Always start drilling at low speed and with the

bit tip in contact with the workpiece. At higher

speeds, the bit is likely to bend if allowed to

rotate freely without contacting the workpiece,

resulting in personal injury.

c) Apply pressure only in direct line with the bit

and do not apply excessive pressure. Bits can

bend causing breakage or loss of control, resul-

ting in personal injury.

SAFETY WARNINGS FOR BATTERY

a) Do not open the battery. Danger of short-

circuiting.

b) Protect the battery against heat, e. g., against

continuous intense sunlight, ﬁre, water, and

moisture. Danger of explosion.

c) In case of damage and improper use of the bat-

tery, vapours may be emitted. Ventilate the area

and seek medical help in case of complaints.

The vapours can irritate the respiratory system.

d) Use the battery only in conjunction with your

Vonroc product. This measure alone protects

the battery against dangerous overload.

e) The battery can be damaged by pointed objects

such as nails or screwdrivers or by force

applied externally. An internal short circuit can

occur and the battery can burn, smoke, explode

or overheat.

SAFETY WARNINGS FOR CHARGER

Intended use

Charge only CD801AA and CD803AA type rechargea-

ble Battery packs with the charger. Other types of bat-

teries may burst causing personal injury and damage.

a) The appliance is not to be used by persons

(including children) with reduced physical, sen-

sory or mental capabilities, or lack of experien-

ce and knowledge, unless they have been given

supervision or instruction.

b) Children being supervised not to play with the

appliance.

c) Do not recharging non-rechargeable batteries!

d) During charging, batteries must be placed in

the well ventilated area!

Electrical safety

Always check that the voltage of the power

supply corresponds to the voltage on the

rating plate.

• Do not use the machine if the mains cable or

the mains plug is damaged.

• Only use extension cables that are suitable

for the power rating of the machine with a

minimum thickness of 1.5 mm2. If you use a ex-

tension cable reel, always fully unroll the cable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc S3-CD509DC Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info