Bedienungsanleitung Vornado AVH2 (Seite 6 von 15) (Englisch)

774188

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

6English

repair.

- Do not sit or stand on product.

- Never use the cord as a handle or otherwise yank, strain or

stretch the power cord.

- Do not insert or allow foreign objects to enter any ventilation

or exhaust opening as this may cause an electric shock or re,

or damage the heater.

- Check your heater cord and plug connections. A loose tting

outlet can cause the plug to overheat or cause a re. Be

sure plug ts tight in the outlet. Check frequently during use

to make sure plug and outlet are not hot. If so, discontinue

using heater and have outlet replaced by a qualied

electrician.

- Never ignore the signs of an electrical problem, such

as: warm outlet coverplates, sparks when plugging in or

operating, lights ickering/dimming during operation.

Immediately turn off and unplug the appliance if any such

problems are noticed. Contact a qualied electrician to

investigate possible causes before operating the appliance

again.

- Note: Heaters draw more current than small appliances,

overheating of the outlet may occur even if it has not

occurred with the other appliances.

- Before moving, repositioning, servicing, cleaning and when

not in use, use the product controls to turn off the power

and then unplug. To disconnect from outlet, grasp and pull

only the plug. Also, power off and unplug if the product will

be left unattended for an extended period of time or during

electrical storms.

- This appliance has a polarized plug (one blade is wider than

the other.) To reduce the risk of electrical shock, this plug is

intended to t in a polarized outlet only one way. If the plug

does not t fully in the outlet, reverse the plug. If it still does

not t, contact a qualied electrician. Do not attempt to

defeat this safety feature.

- If your heater suddenly stops working:

• This heater is equipped with a thermal cutout safety feature

designed to automatically shut off when overheating is

detected. See the “RESET HEATER” instructions in this

guide to determine how to check and reset the heater.

• If the heater and other electrical products suddenly stop

working at the same time, your home circuit breaker

or fuse may have tripped due to an overload of power.

Consider only running your heater on the “low” setting,

only running one heater at once and unplugging all other

electrical products while running the heater, and/or hiring

an electrician to install an additional circuit to your home’s

electrical system.

SERVICING WARNING—To reduce risk of re, electrical

shock and injury to persons, observe the following:

- Clean your product regularly, only as is instructed in this

manual. Prior to cleaning, turn off the power on your

product and unplug. Do not use gasoline, thinners, solvents,

ammonias or other chemicals for cleaning. Refer to the

CLEANING instructions provided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vornado AVH2 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info