Bedienungsanleitung Vornado PIVOT6 (Seite 6 von 15) (Englisch)

774142

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

6English

unplug the product from the outlet. Replace the fuse as per the user

servicing instructions (follow product marking for proper fuse rating)

and check the product. If the replacement fuse blows, a short-circuit

may be present and the product should be discarded or returned to

an authorized service facility for examination and/or repair.

User Servicing Instructions

1. Using the product controls, turn off the appliance.

2. Grasp the plug (not the cord) and disconnect from the outlet.

3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as

approved by Vornado Consumer Service. For an authorized

replacement fuse, please contact Vornado Consumer Service.

4. Once the replacement is received, use a small at-head

screwdriver to slide open the fuse cover (located on the plug)

(See Fig. A).

5. Remove fuse by using the screwdriver to gently lift each end of

the fuse (See Fig. B).

6. Install the replacement fuse by using the screwdriver to gently

push each metal end of the fuse into the receptacle one at a

time. Do not push on the center of the fuse—it is fragile and

may break.

7. Slide the fuse cover closed using the screwdriver. When

closed, the cover should t completely in the plug. No part of

the cover should stick out (See Fig. C).

8. Plug your appliance into the outlet and turn the power on.

9. If the replacement fuse blows, a short-circuit may be present

and the product should be discarded or returned to an

authorized service facility for examination and/or repair.

Risk of re. Do not replace attachment plug. Contains a safety device

(fuse, AFCI, LCDI) that should not be removed. Discard product if the

attachment plug is damaged.

FCC Compliance Statement

NOTE: This equipment has been tested and complies with Part 15 of

the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This product

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this product does cause harmful interference

to radio or television reception, which can be determined by turning

the product off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the product and the receiver.

Fig. A Fig. B Fig. C

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vornado PIVOT6 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info