766099
38
Zoom out
Zoom in
Vorherige Seite
1/156
Nächste Seite
38 41405 | 02 | 2021 | V3
10. GENERAL OPERATION
The Impuls DUO RF models work similarly to the Impuls DUO, but additional functions have
been added for communication between the energiser and the remote control.
If the energiser is completely switched o and no lights are seen, hardly any energy is
consumed. However, in this state the energiser cannot interact with the remote control.
RF models have a dierent switched o state in which the energiser is still ready to receive
the signal from the remote control. In this state, the control LED ashes blue every three
seconds. If it ashes red, the battery charge is low. Use the main screen to control the
selected energiser.
The selection between the devices is made using the arrow keys. Use the display to check
the fence voltage (kV). If you want to display the supplied voltage (V) instead of the fence
voltage, press the „data selection“ button (16).
At the top right of the remote you will nd the energiser output button (10). With this
button you can adjust the energiser output: 100% or 50%. Your selection will be shown on
the display (8).
There are two power buttons on the remote. Hold down the red power button (15) and
turn the remote control on and o. Press and hold the energiser power button (17) to turn
the energiser on or o.
11. CALIBRATION MODE
Calibration mode assigns the energiser to a remote control.
Turn the energiser ON, then OFF and then hold down the ON/OFF button on the energiser
for at least ve seconds. In the calibration mode, the control LED ashes blue rapidly.
Press and hold the calibration button on the remote control (13) until „P“ appears on the
display.
Use the arrow keys to assign the energiser a desired identication number.
Place the remote control near the energiser, within 20 cm or less, and press the
calibration button (13).
If the calibration fails, please try again.
38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Voss Impuls duo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Voss Impuls duo

Voss Impuls duo Bedienungsanleitung - Englisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info