Troubleshooting (continued)
You may have set the sensitivity level to a very low level. If you do
so, the baby unit will not detect sounds that is too soft or light. You
may need to adjust the sensitivity level to a higher level (pages 24
and 25).
Large obstructions may impact the reception. Try to relocate the
baby unit, away from large obstructions such as walls and doors.
Remove and install the battery again. Turn on the baby unit and the
parent unit. Allow up to one minute for the parent unit and the baby
unit to synchronize.
Other electronic products may cause interference with your video
and audio monitor. Try installing your video and audio monitor as
far away from these electronic devices as possible: wireless routers,
radios, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and cordless telephones.
The light ashes on the parent unit.
Charge the battery in the parent unit for up to 12 hours.
Completely remove and install the battery again and use it until fully
depleted, then recharge the battery in the parent unit for up to
12 hours.
If the above measures do not correct the problem, replace the
battery.
The battery does not charge in the parent unit or the
parent unit battery does not accept charge.
Make sure the battery is installed in the parent unit battery compartment
correctly. The light on the parent unit should be on.
Completely remove and install the battery again, then charge for up to
12 hours.
If light on the parent unit is not on, refer to The light on the
parent unit is off below.
If the battery is completely depleted, it may take up to 30 minutes to
charge the parent unit before it can be used for a very short time
(page 9).
Purchase a new battery. Refer to Parent unit battery installation
(page 5) and Parent unit battery charging (page 9).
•
•
•
•
•
•
•
•
•
•
•
•
