444757
35
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
35
35
Index
Contents
Index
Contents
TESTING YOUR TABLET AND PEN
1. Turn on your computer and wait until the system has fully loaded.
2. Check the connection. The tablet ExpressKeys should glow whenever the tablet is properly connected
and your computer has registered it as a USB device. If not:
Make sure the tablet USB cable is securely connected to the tablet and to an active USB port on your
computer.
If you are connecting the tablet to a USB hub (or hub device such as a keyboard with USB ports), be
sure the USB hub is properly connected to your computer and is active.
Check the cable for damage or try using a different, compatible cable.
Connect the tablet to a different USB port or try connecting to the USB port on another computer.
If the tablet ExpressKeys do not illuminate after your computer is on and has finished booting up,
your USB port may be disabled. Verify that you have connected the tablet to an active USB port.
3. Activate the tablet diagnostics. First open the Pen Tablet control panel and select the T
ABLET tab.
Use the pull-down menus to D
ISABLE all of the ExpressKeys. Now press both the upper left and lower
right ExpressKeys and hold them down for three (3) seconds.
Do a quick check of the ExpressKeys by pressing each one in turn. All of the ExpressKeys should
glow at a brighter level each time you press a key.
Do a quick check of the Touch Ring by sliding your finger around it. All of the ExpressKeys should
glow at a brighter level when you touch the ring.
Check the pen by first opening the Pen Tablet control panel and selecting the P
EN tab. Click on the
D
EFAULT button to return the pen to its default settings. Next:
A. Touch the pen tip and then the eraser to the tablet active area. All of the ExpressKeys should
glow brightly each time the tip or eraser makes contact with the tablet surface.
B. Without applying pressure to the pen tip, hold the pen tip within approximately 5 mm (0.20 inch)
of the tablet surface and press each pen button in turn. All of the ExpressKeys should glow
brightly each time a pen button is pressed
C. While still within proximity, but without touching the tablet surface, move your pen across the
active area of the tablet. The screen cursor should move in the corresponding direction on your
monitor or display screen.
When you are done, exit the diagnostics mode by pressing both the upper left and lower right
ExpressKeys and holding them down for three (3) seconds. In the Pen Tablet control panel, select the
T
ABLET tab and use the pull-down menus to return the ExpressKeys to their previous settings.
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Wacom bamboo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Wacom bamboo

Wacom bamboo Bedienungsanleitung - Deutsch - 90 seiten

Wacom bamboo Bedienungsanleitung - Holländisch - 90 seiten

Wacom bamboo Bedienungsanleitung - Holländisch - 60 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info