517974
22
Zoom out
Zoom in
Vorherige Seite
1/120
Nächste Seite
Mounting the camera PerfectView
22
Please observe the following instructions:
z Wherever possible, lay cables inside the vehicle, as they are better protected there
than outside the vehicle.
If you do need to lay a cable outside the vehicle, ensure that it is well secured (use
additional cable ties, insulating tape etc.).
z To prevent damage to the cables, when laying them, ensure that they are far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light sys-
tems, fans, heater etc.). Use corrugated piping or other protective materials to protect
against mechanical wear.
z Wrap the insulating tape supplied around the plug connections of the connecting ca-
bles and every connection on a cable (including inside the vehicle) to protect from
penetrating water (see fig. 5 B, page 4).
z When laying electric connections, ensure that
they are not kinked or twisted
they do not rub on edges
they are not laid in sharp edged ducts without protection (fig. 2, page 3).
z Attach the cables securely in the vehicles to prevent tripping hazards. Use cable
binders, insulating tape or glue the cables in place.
z Protect every through-hole made in the bodywork against water penetration , e.g. by
using a cable with a sealant and by spraying the cable and the the cable sleeve with
sealant.
I
Note
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
8 Mounting the camera
I
Note
If installing the camera alters the vehicle height or length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of vehicle documents verifying that your
vehicle has passed this inspection.
a
Caution!
Select a location for the camera and attach it so securely that it cannot under
any circumstances fall off and injure bystanders (e.g. by being knocked off by
branches brushing over the roof of the vehicle).
Observe the following installation instructions:
z To provide a suitable viewing angle, the camera must be attached at a height of at
least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
CAM30_CAM40.book Seite 22 Donnerstag, 14. Januar 2010 5:32 17
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Waeco CAM40 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info