GB
17
W 550
Adjusting the Material Volume (Fig. 7)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left ➟ lower material volume
+ turn to the right ➟ higher material volume
Spray Technique
● The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
● Cover all surfaces not to be sprayed.
● Cover screw threads or similar parts of the target object.
● It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Begin spraying outside of the target area and avoid interruptions
inside the target area.
● Correct (Fig. 8 A) Be sure to hold the spray gun at an even distance of
approx. 5 - 15 cm to the target object.
● Incorrect (Fig. 8 B) Heavy spray fog build-up, uneven surface quality.
● Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
● An even movement of the spray gun results in an even surface quality.
● When coating material builds up on the nozzle (A) and air cap (B) (Fig. 9), clean
both parts with a solvent or water.
Interruption of Work till 4 Hours
● Turn the machine off.
● When processing 2-component varnishes, clean the device immediately.
Taking Out of Operation and Cleaning
1. Unplug the power plug. Activate the trigger guard so that the coating material in
the spray gun flows back into the container.
2. Divide the spray gun. Press the hook (Fig. 4b "click") slightly downwards. Turn the
gun front part and gun rear part against each other.
3. Unscrew the container. Empty any remaining coating material back into the
material tin.
4. Pre-clean the container and feed tube with a brush.
5. Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21°C .
6. Assemble the gun again (Fig. 4).
7. Insert the power plug, turn on the machine and spray the solvent or water into a
container or a cloth.
