Your Wahl clipper blades were oiled and aligned before leaving our
factory; however, it is possible for blades to get bumped out of
alignment. Blades must be realigned if they have been removed for
cleaning or replacement.
1.If your clipper has a taper lever - position the taper lever in the close
cut position.
2. End of top blade teeth should be approximately 1/32" (.64mm) back
from bottom blade. This is important so that the clipper does not cut
too close or allow the moving cutter to touch the skin.’
3.Extreme left-hand tooth of top blade must be covering or to the left
of the first small tooth of bottom blade.
4. Extreme right-hand tooth of top blade must be touching the big
tooth on the bottom blade.
If blade alignment is incorrect, add a few drops of oil to the blades,
turn clipper "ON" for a few moments, turn "OFF" and unplug. Loosen
screws slightly and adjust. Tighten screws after blades are aligned.
OILING BLADES
The blades of your new clipper should be oiled every few haircuts.
Simply place a few drops of oil on the teeth of the blades. Use only
the Wahl oil included in the pack. Due to the high speed of your Wahl
clipper, the correct type of oil must be used. Do not use hair oil,
grease or any oil mixed with
kerosene or any solvent, as the
solvent will evaporate and leave the
thick oil slowing down the blades.
Wahl Clipper Oil is a very thin,
natural oil which will not evaporate
and will not slow down the blades.
POWER SCREW (Not found on all models of Wahl Clippers)
If your clipper has a power screw, it has been adjusted for peak
efficiency before leaving the factory. However, if voltage in your home
is low, you may need to readjust it.
To adjust power, use the plastic brush, a
screwdriver or a thin coin to turn power
screw in a clockwise direction until the
arm strikes the coil, making a noise.
Then, slowly turn power screw out
(counterclockwise), just until noise
stops. This is the maximum power setting.
The cord should not be used to pull the clipper. Since freedom of
movement needs to be maintained, care should be used to keep the
cord untwisted and unobstructed. When stored, the cord should be
coiled and the unit placed in original box or storage pouch.
TAPER LEVER
Some Wahl clippers are equipped with an adjustable taper lever. The
taper lever is conveniently located near your thumb (if you're right-
handed), so it can easily be adjusted while the clipper is in your hand.
The taper lever adds versatility to your clipper by allowing you to
gradually change the closeness of your cut without a guide comb.
When the lever is in the uppermost position, the blades will give you
the closest cut and leave the hair very short. Pushing the lever
downward gradually increases the cutting length. In its lowest
position, the taper lever will leave the hair approximately the same
length as the 1/8" guide comb.
The taper lever will also extend the use of your blades since a
different cutting edge is used in each
setting. In addition, if extremely heavy
haircutting has jammed the blades, it
will help you remove hair that has
become wedged between the two
blades without removing the blades.
While the clipper is running, rapidly
move the lever from "close cut" to
"longer cut" a couple of times. Doing this each time you've finished
using your clipper will help keep the blades clear of cut hair. If your
clipper stops cutting and this does not help, your cutting blades may
be dull. Either replace them or return them to Wahl for sharpening.
IMPORTANT SAFEGUARDS
When using your electrical appliance, basic precautions should
always be followed, including the points listed below. (Read all
instructions before using.)
DANGER
To reduce the risk of death or injury by electric shock:
1. Do not reach for an appliance that has fallen into water. Unplug
immediately. Some electrical parts inside the clipper are electrically
live, even with the switch “off.”
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be pulled into a
tub or sink. Do not place in or drop into water or other liquid.
4.Always unplug this appliance from the electrical outlet immediately
after using.
5. Unplug this appliance before cleaning.
WARNING
To reduce the risk of burns, fire, electric shock or injury to persons:
1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used by, on,
or near children or invalids.
3. Use this appliance only for its intended use, as described in this
manual. Do not use attachments not recommended by the manufac-
turer.
4. Never operate this appliance if it has a damaged cord or plug, if it is
not working properly, if it has been dropped or damaged, or dropped
into water. Return the appliance to Wahl Clipper Corporation for
examination and repair.
5. Keep the cord away from heated surfaces.
6. Never operate the appliance with the air openings blocked or while
on a soft combustible surface, such as a bed or couch, where air
openings may be blocked. Keep the air openings (if any) free from
lint, hair or the like.
7. Never drop or insert any object into any opening on this appliance.
8. Do not use outdoors or operate with aerosol (spray) products or
where oxygen is being administered.
9. Do not use this appliance with a damaged or broken comb nor with
teeth missing from the blades, as injury may occur. Before use, make
certain blades are aligned properly.
10. During use, do not place or leave appliance where it may be
damaged by an animal or exposed to weather.
11. To disconnect, turn all controls to “OFF,” then remove plug from
outlet.
CLIPPER
CARE
INSTRUCTIONS
READ ALL INSTRUCTIONS AND SAFEGUARDS BEFORE USING YOUR CLIPPER
Brauchen Sie Hilfe? Stellen Sie Ihre Frage.
Missbrauch melden von Frage und/oder Antwort
Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.
Art des Missbrauchs:
Forenregeln
Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:
Lesen Sie zuerst die Anleitung;
Schauen Sie nach, ob die Frage bereits gestellt wurde;
Stellen Sie die Frage so deutlich wie nur einigermaßen möglich;
Erwähnen Sie was Sie bereits versucht haben um das Problem zu lösen;
Ist Ihr Problem von einem Besucher gelöst dann lassen Sie ihn / sie wissen in diesem Forum;
Falls Sie reagieren möchten, so verwenden Sie bitte das Antworten- Formular;
Da ihre Frage für alle Besucher sichtbar ist, sollten Sie lieber keine persönliche Daten erwähnen.
Neu registrieren
Registrieren auf E - Mails für Wahl Tondeuse diverse types wenn:
neue Frage gestellt werden
neue Handbücher vorhanden sind
Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.
Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.
Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.
Ihre Frage wurde zu diesem Forum hinzugefügt
Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.
