Bedienungsanleitung Wamsler City (Seite 26 von 84) (Deutsch, Englisch, Französisch, Italienisch)

813196

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Ensure that the ashtray should be fully pushed into the equipment.

Warning! In order to keep the air clean and safeguard the fireplace, do not

exceed the specified maximum fuel quantity, otherwise overheating may oc-

cur, which potentially damage the equipment. Such damage is not covered

with any guarantee. Only a single layer of fuel is allowable to be prepared in

the fireplace. Try to reach lower heating performance only by decreasing the

quantity of fuel, and not by cutting the primary air supply.

1.5 Cleaning and maintenance

After the heating season, it is recommended to clean the fireplace and the flue gas

pipes carefully. Any dropping heating performance is almost always the conse-

quence of the strong contamination of the flues. For cleaning, the baffle plate (Pic-

ture7) is to be pulled forward. This way, the flues can be cleaned from the inside or

– after removing the flue gas pipe – from above. After cleaning, the baffle plate

(Picture 7) is be pushed back fully again.

Warning!

Following every heating season you are advised to examine the fireplace thor-

oughly. If any repair or reconditioning is needed, please, contact your local dealer

in a timely manner, and specify the model number and serial number of your

equipment (as seen on the model plate). External surfaces may be maintained only

after the fireplace cooled down, and following the first commissioning. Use cold

water for cleaning, or soap, washing ingredient in extraordinary cases, then wipe it

dry. Before its first use, clean the ROBAX inspection glass with a wet and clean

cloth, and then put a few drops of glass–ceramics cleaner onto both sides of the

glass, and spread them with the use of kitchen paper tissues. It provides an invisi-

ble film on the valuable surface of the Robax glass. This film helps to keep the

glass clean, and facilitates regular cleaning operations. ROBAX S for slightly con-

taminated surfaces – a commercially available glass surface cleaning agent – may

as well be used for the cleaning of the medium or strongly contaminated glass sur-

faces of the fireplace. Towards this end, spray small quantities of the agent to the

cold surfaces, spread it, and wash it down with a wet cloth, followed by drying with

a clean, soft cloth. In case there are sticky fuel deposits on these surfaces, first

scale simply them with a ceramic-plate scraper held in flat angle, and then clean

the surfaces as described above.

Cleaning of the ceramic surfaces dirt and grease are to be removed with soap

and water.

Cleaning of the soapstone: the soapstone is a natural stone, therefore minor

colour differences may occur; as it is normal, they may not serve as a basis for

quality complaints! To clean the soapstone from dirt and fat with water and soap, as

well as small scratches, use sand paper (grain size 240).

Warning: Under no circumstances you may use sponge, scouring, aggressive

or scratching cleaning agents! If the grate is blocked so that the equipment can-

not serve the intended function, the grate is to be removed for cleaning.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler City Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info