Bedienungsanleitung Wamsler COLORADO DELUXE (Seite 26 von 83) (Deutsch, Englisch, Französisch, Italienisch)

813212

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Warning!

When opening the furnace chamber door, any incorrect handling or

insufficient draught may induce smoke. Always ensure that the furnace

chamber door may be opened only slowly, first just to a small extent, and

then fully after a few seconds. In addition, if you intend to put additional fuel

into the fire, before the opening of the door only there may be only ember bed

in the burning space, i.e. no flames may be visible.

Led into the burning space in correspondence with the existing conditions, the

secondary air provides for the follow-up burning of the combustible components of

in the burning space. This in fact means smoke and soot-poor burning, which

contributes to the protection of the environment. If you wish to commission the

fireplace in a transitional period, please, please first examine the chimney draught,

as it can be especially weak at high external temperatures. Towards this end, hold

a burning match in the slightly opened feeding door. If the flame is not drawn

significantly by the draught, then a so-called starting fire is to be set first. Towards

this end, burn wood chips/wool in the fireplace or the cleaning hole of the chimney.

The fire grate is to be cleaned before every kindling to ensure the proper inflow of

air for burning. The ashtray is to be emptied regularly. Should the equipment be

extremely hot, use the gloves (pic. 4). Please, be careful not to dispose glowing

materials into the waste bin.

Ensure that the ashtray should be fully pushed into the equipment.

Warning! In order to keep the air clean and safeguard the fireplace, do not exceed

the specified maximum fuel quantity, otherwise overheating may occur, which

potentially damage the equipment. Such damage is not covered with any

guarantee. Only a single layer of fuel is allowable to be prepared in the fireplace.

Try to reach lower heating performance only by decreasing the quantity of fuel, and

not by cutting the primary air supply.

1.5 Cleaning and maintenance

After the heating season, it is recommended to clean the fireplace and the flue gas

pipes carefully. Any dropping heating performance is almost always the

consequence of the strong contamination of the flues. For cleaning, the baffle plate

is to be pulled forward. This way, the flues can be cleaned from the inside or – after

removing the flue gas pipe – from above. After cleaning, the baffle plate is be

pushed back fully again.

Warning!

Following every heating season you are advised to examine the fireplace

thoroughly. If any repair or reconditioning is needed, please, contact your local

dealer in a timely manner, and specify the model number and serial number of your

equipment (as seen on the model plate). External surfaces may be maintained only

after the fireplace cooled down, and following the first commissioning. Use cold

water for cleaning, or soap, washing ingredient in extraordinary cases, then wipe it

dry. Before its first use, clean the ROBAX inspection glass with a wet and clean

cloth, and then put a few drops of glass–ceramics cleaner onto both sides of the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler COLORADO DELUXE Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info