Bedienungsanleitung Wamsler Linz (Seite 25 von 84) (Deutsch, Englisch, Französisch, Italienisch)

813203

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Filling quantities 6 kW

- Split billet: max. length: 25 cm, max. 2 billets per filling, appr. 1,4 kg

- Lignite briquette: max. 1,7 kg

Filling quantities continuos combustion:

- Lignite briquette: max. 5,8 kg

IT IS NOT ALLOWED to burn waste, fine chipping, bark, wood handled with preven-

tive chemicals, furthermore paper and cardboard. For kindling please use wood scrap-

ings or grill starter but never use liquid auxiliaries!

The first kindling

• At the first fire set-up could be a little smoke, but is not dangerous, normal!

In this time, please ventilate the room carefully!

Warning! Upon the first kindling, smoke and unpleasant smell may be gener-

ated. Always ensure the proper ventilation of the room (by opening windows

and doors), and heat the fireplace at maximum rated heating performance. If

with the first heating the maximum temperature is not reached, the above-

mentioned effects may as well arise later on.

• Before installation pull out the delivery securer off the refractory brick through the

furnace chamber (picture 6).

Open the door by raising the handle (picture 2). If the equipment is hot, you can use

insulated gloves. Adjust the primary air regulator and the fuel switch (picture 3) ac-

cording to the Table 2. Put coal lighter or wood wool onto the fire grate, followed by

wood chips. First insert small pieces of wood, and then larger ones, light them and

close the door again. When the wood burns quickly, and leaves sufficient glowing

embers, put additional fuel on the fire. Thereafter, adjust the primary air regulator and

the fuel switch according to the Table 2 („Adjustment of the burning air”). The first

kindling should be performed “finely” with little fuel only, so that the parts of the fire-

place are adapted to heat. During the first kindling, the generation of smell is normal

and absolutely undangerous.

1.3 Putting out of operation

• Let the glowing ember burn to ashes and the fire-place get cold.

• Empty the furnace chamber and the ash bin.

• Close the doors, and shut off the primary air regulator (position I) and the fuel

switch (position K).

1.4 Heating instructions

The fireplace should be operated only with closed furnace chamber door. Fireplaces

belonging to type 1 have self-locking furnace chamber doors. These doors may be

opened only for kindling, loading or when cleaning the furnace chamber (otherwise

draught problems may occur with other equipment connected to the same chimney).

Warning!

When opening the furnace chamber door, any incorrect handling or insufficient

draught may induce smoke. Always ensure that the furnace chamber door may

be opened only slowly, first just to a small extent, and then fully after a few sec-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler Linz Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info