Bedienungsanleitung Wamsler MODULO G (Seite 24 von 68) (Deutsch, Englisch, Französisch, Italienisch)

813206

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

coal lighter or wood wool into the fire grate, followed by wood chips. First insert small

pieces of wood, and then larger ones, light them and close the door again. When the

wood burns quickly, and leaves sufficient glowing embers, put additional fuel on the fire.

Thereafter, adjust the primary air regulator and secondary air regulator according to the

Table 1 („Adjustment of the burning air”). The first kindling should be performed “finely”

with little fuel only, so that the parts of the fireplace be adapted to heat. During the first

kindling, the generation of smell is normal.

1.3 Putting out of operation

• Let the glowing ember burn to ashes and the fire-place get cold.

• Empty the furnace chamber.

• Close the doors and push the primary air regulator totally closed.

1.4 Heating instructions

The fireplace should be operated only with closed furnace chamber door. Fireplaces

belonging to type 1 have self-locking furnace chamber doors. These doors may be

opened only for kindling, loading or when cleaning the furnace chamber (otherwise

draught problems may occur with other equipment connected to the same chimney).

Warning!

When opening the furnace chamber door, any incorrect handling or insufficient

draught may induce smoke. Always ensure that the furnace chamber door may

be opened only slowly, first just to a small extent, and then fully after a few sec-

onds. In addition, if you intend to put additional fuel into the fire, before the open-

ing of the door only there may be only ember bed in the burning space, i.e. no

flames may be visible.

Led into the burning space in correspondence with the existing conditions, the second-

ary air provides for the follow-up burning of the combustible components of in the burn-

ing space. This in fact means smoke and soot-poor burning, which contributes to the

protection of the environment. If you wish to commission the fireplace in a transitional

period, please, please first examine the chimney draught, as it can be especially weak

at high external temperatures. Towards this end, hold a burning match in the slightly

opened feeding door. If the flame is not drawn significantly by the draught, then a so-

called starting fire is to be set first. Towards this end, burn wood chips/wool in the fire-

place or the cleaning hole of the chimney. Please, be careful not to dispose glowing

materials into the waste bin.

Warning! In order to keep the air clean and safeguard the fireplace, do not exceed

the specified maximum fuel quantity, otherwise overheating may occur, which

potentially damage the equipment. Such damage is not covered with any guaran-

tee. Only a single layer of fuel is allowable to be prepared in the fireplace. Try to

reach lower heating performance only by decreasing the quantity of fuel, and not

by cutting the primary air supply.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler MODULO G Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info