27
Warning! Upon the first kindling, smoke and unpleasant smell may be
generated. Always ensure the proper ventilation of the room (by opening
windows and doors), and heat the fireplace at maximum rated heating
performance. If with the first heating the maximum temperature is not
reached, the above-mentioned effects may as well arise later on.
• Before installation pull out the delivery securer off the refractory brick through
the furnace chamber (picture no. 6).
Open the door by raising the handle (Picture 2). If the equipment is hot, you can
use insulated gloves. Adjust the primary air regulator and the fuel switch (Picture
3) according to the Table 2. Put coal lighter or wood wool onto the fire grate,
followed by wood chips. First insert small pieces of wood, and then larger ones,
light them and close the door again. When the wood burns quickly, and leaves
sufficient glowing embers, put additional fuel on the fire. Thereafter, adjust the
primary air regulator and the fuel switch according to the Table 2 („Adjustment of
the burning air”). The first kindling should be performed “finely” with little fuel only,
so that the parts of the fireplace are adapted to heat. During the first kindling, the
generation of smell is normal and absolutely undangerous.
1.3 Putting out of operation
• Let the glowing ember burn to ashes and the fire-place get cold.
• Empty the furnace chamber and the ash bin.
• Close the doors, and shut off the primary air regulator (position I) and the fuel
switch (position K).
1.4 Heating instructions
The fireplace should be operated only with closed furnace chamber door.
Fireplaces belonging to type 1 have self-locking furnace chamber doors. These
doors may be opened only for kindling, loading or when cleaning the furnace
chamber (otherwise draught problems may occur with other equipment connected
to the same chimney).
Warning!
When opening the furnace chamber door, any incorrect handling or
insufficient draught may induce smoke. Always ensure that the furnace
chamber door may be opened only slowly, first just to a small extent, and
then fully after a few seconds. In addition, if you intend to put additional fuel
into the fire, before the opening of the door only there may be only ember
bed in the burning space, i.e. no flames may be visible.
Led into the burning space in correspondence with the existing conditions, the
secondary air provides for the follow-up burning of the combustible components of
in the burning space. This in fact means smoke and soot-poor burning, which
contributes to the protection of the environment. If you wish to commission the
fireplace in a transitional period, please, please first examine the chimney draught,
as it can be especially weak at high external temperatures. Towards this end, hold
