24
match in the slightly opened feeding door. If the flame is not drawn significantly by
the draught, then a so-called starting fire is to be set first. Towards this end, burn
wood chips/wool in the fireplace or the cleaning hole of the chimney. The fire grate
is to be cleaned before every kindling to ensure the proper inflow of air for burning.
The ashtray is to be emptied regularly (Figure 4). Should the equipment be ex-
tremely hot, use the gloves provided. Please, be careful not to dispose glowing
materials into the waste bin.
Ensure that the ashtray should be fully pushed into the equipment.
Warning! In order to keep the air clean and safeguard the fireplace, do not
exceed the specified maximum fuel quantity, otherwise overheating may oc-
cur, which potentially damage the equipment. Such damage is not covered
with any guarantee. Only a single layer of fuel is allowable to be prepared in
the fireplace. Try to reach lower heating performance only by decreasing the
quantity of fuel, and not by cutting the primary air supply.
1.5 Cleaning and maintenance
After the heating season, it is recommended to clean the fireplace and the flue gas
pipes carefully. Any dropping heating performance is almost always the conse-
quence of the strong contamination of the flues. For cleaning, the baffle plate (Pic-
ture7) is to be pulled forward. This way, the flues can be cleaned from the inside or
– after removing the flue gas pipe – from above. After cleaning, the baffle plate
(Picture 7) is be pushed back fully again.
Warning!
Following every heating season you are advised to examine the fireplace thorough-
ly. If any repair or reconditioning is needed, please, contact your local dealer in a
timely manner, and specify the model number and serial number of your equipment
(as seen on the model plate). External surfaces may be maintained only after the
fireplace cooled down, and following the first commissioning. Use cold water for
cleaning, or soap, washing ingredient in extraordinary cases, then wipe it dry. Be-
fore its first use, clean the ROBAX inspection glass with a wet and clean cloth, and
then put a few drops of glass–ceramics cleaner onto both sides of the glass, and
spread them with the use of kitchen paper tissues. It provides an invisible film on
the valuable surface of the Robax glass. This film helps to keep the glass clean,
and facilitates regular cleaning operations. ROBAX S for slightly contaminated
surfaces – a commercially available glass surface cleaning agent – may as well be
used for the cleaning of the medium or strongly contaminated glass surfaces of the
fireplace. Towards this end, spray small quantities of the agent to the cold surfaces,
spread it, and wash it down with a wet cloth, followed by drying with a clean, soft
cloth. In case there are sticky fuel deposits on these surfaces, first scale simply
them with a ceramic-plate scraper held in flat angle, and then clean the surfaces as
described above.
Cleaning of the ceramic surfaces dirt and grease are to be removed with soap
and water.
