Bedienungsanleitung Wamsler W3-90 (Seite 28 von 116) (Deutsch, Englisch, Französisch, Italienisch)

813243

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

1. Installation

1.1 Safety measures

1. The stoves are tested to DIN EN 12815 (see identification plate).

2. For installation and for flue gas connections, the requirements of the Fire Regula-

tions (FeuVO in Germany) apply, as well as local building regulations such as the

following technical standards DIN 4705, DIN EN 13384, DIN 18160, DIN EN

1856-2 and DIN EN 15287. In order for the stove to function correctly the chimney

to which you want to connect the stove must be in good condition.

3. Before first use and before connecting to the chimney, you must read the Instruc-

tions for Use carefully and inform the local authority responsible for approving

heating systems.

4. While installing the stove you are recommended to wear clean cotton gloves, in

order to avoid leaving fingerprints which can be difficult to remove afterwards.

5. In the interests both of clean air, and of the safe functioning of the stove, the fuel

quantities listed in the Instructions for Use should never be exceeded, and the

doors of the stove must be shut during use to avoid the risk of overheating, which

can lead to damage to the stove. Damage due to this cause is not covered by the

guarantee.

6. The stove doors must remain shut at all times while the stove is in use.

7. Permitted fuels are:

- Natural chopped firewood (up to 33 cm max. in length)

- Lignite (brown coal) briquettes (see permitted fuels in the Instructions for Use)

8. Never use liquid fire starters. Use either special firelighters or wood shavings.

9. Burning rubbish, fine chips, bark, coal slack, chips from planing, damp wood or

wood treated with preservative, paper, cardboard or similar is not permitted.

10. The first time the stove is heated there may be some smoke and an unpleasant

smell. Make sure that the room is well ventilated (open windows and doors) and

heat for at least an hour at the maximum nominal heat load. If the maximum tem-

perature is not reached the first time the stove is heated, then there may be fur-

ther unpleasant smells at a later date.

11. All controls and settings must be used as indicated in the Instructions for Use.

When the stove is hot, please handle only using the implements or protective

gloves provided.

12. If the stove is not working correctly, or if the chimney is not drawing properly,

smoke may appear when the fire door is opened. It is very important to only open

the fire door slowly, initially just a crack, then wait a few seconds before opening

fully. In addition, before opening the fire door to top up the fuel, make sure that

only glowing material is present: there must not be any visible flames.

13. Do not place any flammable items in the warming drawer or on the surface of the

stove.

14. When in use, all surfaces and particularly the glass doors and handles and other

controls can become very hot. Make children, young people, older people and

animals aware of this danger, and keep them away from this source of heat when

the stove is being used. Use the protective gloves or the implements provided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler W3-90 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info