Bedienungsanleitung Wanders 75 (Seite 20 von 64) (Deutsch, Englisch, Holländisch, Französisch)

694505

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Installation Instructions for the Square

General instructions 20

Preparation 20

Installation 21

Connecting the stove 21

Repairs 22

General instructions

The Square is tested in accordance with the international

EN 13229 standardization, and has an extra additional

standardization for optimally environment-friendly

heating devices related to ue gases (Section 15a B-Vg.

Des BmfWA). The stove can be connected to a ue tube

to which several stoves are connected. The ue pipe has

a diameter of 150 millimetres.

The heating device must be placed by an acknowledged

installer and according to the installation instructions

given below. The national and local rules and regulations

for placing and using wood-burning stoves are equally

applicable. WANDERS does not give any guarantee if

the Square is connected or installed incompletely or

incorrectly.

It is not allowed to place the stove in:

• Arcades and corridors accessible to the public.

• Stairwells, except in buildings with no more than 2

dwellings.

• Spaces where highly ammable or explosive materials

are used.

• Spaces where an exhaust system is used or where a

mechanical exhaust system is placed, except when

the air supply is taken directly from outside to assure

a hazardless combustion.

Preparation

The chimney ue

Before placing the stove you must observe the following

points:

• If the stove is connected to an existing chimney, you

must rst have the chimney professionally cleaned

and checked by a qualied chimney sweep company.

Any cut-o valves or stop valves must be removed.

• The ue tube of the stove must be connected with the

chimney without diversions.

• The underpressure in the chimney must be at least 12

Pa or 0.12 mbar.

• The chimney ue must always end up in outlet area 1

(see the drawing and the table below)

• At the time of placing the stove, the chimney ue

must be clean, leak-proof and without obstructions,

and must have a diameter of 150 mm.

• Any bends in the ue tube must not exceed 45

degrees.

• Ensure that the chimney tube can discharge the ue

gases adequately, properly and safely.

Fire Safety

For reasons of re safety is it important to observe the

instructions below before installing the stove.

1. If the oor around the stove is made of combustible

material, you must use a oor slab.

The oor slab must measure at least:

- 50 cm from the stove on the front side of the door

- 30 cm from the stove on the sides of the door.

2. Keep at least a distance of 80 cm between the stove

and combustible objects such as curtains, wooden

objects (cupboards and paintings) and glass objects.

Keep the same distance from the ue tube.

3. Wooden construction parts within the radiation

range of the stove (80 cm from the exterior of the

stove) must be covered with reproof material.

4. If the ue tube goes through a ceiling and/or roof

that consist of ammable materials, the ceiling and

the roof must be covered with reproof materials all

3 3

A X

X > 23˚

X < 23˚

500 mm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders 75 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info