Bedienungsanleitung Wanders Balsa 100 (Seite 24 von 64) (Deutsch, Englisch, Holländisch, Französisch)

571834

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

The Balsa must not be built into the wall, and must be placed on a  oor that is solid enough to hold the

appliance. The distance from the Balsa to the rear wall must be at least 10 cm, and there must be a free space

of at least 80 centimetres to the right and left side of the  replace. Be sure to place the Balsa on a solid  oor

plumb under the  ue pipe.

Insulation

Due to the high temperatures of the exterior walls (up to approximately 150 °C or 300 °F) it is prohibited to

have or to place any combustible materials close to the channel system. The entire concentric pipe system

should be encased with  reproof material from the place where it is out of sight up to the outlet in the exterior

wall. Ventilate the encased concentric pipe system by placing a grate near the  oor and the ceiling on every

 oor. Use universal wall clips with a diameter of 150 mm for anchoring the concentric pipe system.

Do not insulate the concentric channel

If an existing chimney is used,  rst make sure whether the chimney is su ciently insulated and is wide

enough to accommodate the concentric pipe system. If the chimney was previously used as a wood-burning

or coal- red stove, it must  rst be professionally cleaned. You must use special WANDERS connecting sets for

connecting a gas hearth to an existing chimney.

Gas connection

• Use a feed pipe with an approved G3/8” stop cock with coupling.

• De-aerate the supply pipe before  tting and fastening the appliance.

• Avoid tension on the operating valve and pipes to avoid gas leakage.

• Check if the connection is gastight.

Placing the concentric channel system

The appliance is approved according to the European CE regulations for gas appliances with the WANDERS

concentric  ue systems (Ø 100 / 150 mm) and are to used only in that combination. The warranty will be partly

or entirely invalid if another system is used during installation. The WANDERS concentric system (Ø 100 / 150

mm) can be used with existing situations or newly built situations.

Instructions for placing the out ow

The out ow of the pipe system can be placed on top of the roof or against the side

wall of the house.

Out ow on top of the roof

When placing the out ow on top of the roof, make sure that there is a distance of at

least 50 cm between the out ow and the edges of the roof, with the exception of a

possible existing ridge. You must also take the place of the out ow into account in

relation to the existing ventilation openings, movable windows and combustion air

supply provisions. Please consult the national and local requirements.

Out ow into the wall

When placing the out ow into the side wall, make sure that there is distance of at least

50 cm between the out ow and the corners of the building, eaves, gutters, balconies

and etceteras. You need not have this distance when the out ow runs to at least the

front side of the overhanging part.

Min.

50 cm

Min.

50 cm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Balsa 100 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info