Bedienungsanleitung Wanders Danta 1400 (Seite 7 von 36) (Englisch)

571828

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

installation, servicing and user instructions manual | GB + IE

• Simultaneously press and hold buttons B & C (Star and Large Flame), until a short acoustic beep conrms the

start sequence has begun; release the buttons.

• Continuing signals conrm the ignition is in process.

• Once pilot ignition is conrmed, there will be gas ow and the main burner will ignite.

• Repeat process if pilot ignition fails.

2.7 To Turn the appliance OFF

Press the OFF button (Button B g. 1.1) on the Handset. This will extinguish all Burners including Pilot.

Note: - Repeated presses of the small ame (Button D g. 1.1) will turn the main burner OFF, but will leave the Pilot

alight.

2.8 Adjusting the Flame setting

To increase the ame height; press the large ame button (Button C g. 1.1).

To decrease the ame height; press the small ame button (Button D g. 1.1).

2.9 Using the "Eect" Burner

Note: The solenoid valve will not operate for one minute after Ignition.

The solenoid valve cannot be operated manually. If the battery runs down, the solenoid will remain in its

last operating position.

During normal operation the solenoid will be reset to the ON (Open) when the Gas Valve is switched OFF

via the Handset.

Upon ignition both "Main" and "Eect" burner are ON.

To switch the "Eect" burner OFF, simultaneously press the OFF and Large Flame buttons (buttons B & C g. 1.1).

To switch the "Eect" burner ON, simultaneously press the SET and Large Flame buttons (buttons A & C g. 1.1).

Printed instructions are located on the battery cover on the rear of the handset.

2.10 Setting °C/24 hour or °F/12 hour clock

Simultaneously press OFF and Small Flame buttons (buttons B & D g. 1.1) until display changes from Fahrenheit/12

hour clock to Celsius/24 hour clock and vice versa.

2.11 Setting the Time

The display will ash after either:

• Installing the battery or

• Simultaneously pressing the Large Flame Button and Small Flame Button (buttons C & D g. 1.1)

Press the Large Flame button (button C g. 1.1) to set the hour.

Press the Small Flame button (button D g. 1.1) to set the minutes.

Press OFF (button B g. 1.1) to return to standard operating mode or simply wait and it will return to standard

mode after approximately 15 seconds.

2.12 Cleaning and Maintenance

This appliance should be inspected and serviced once a year by a qualied, competent and registered person.

The inspection and maintenance must at least ensure that the appliance is working correctly and safely. It is

advisable to clean the appliance of any dust and debris before regularly during the heating season and especially

if the appliance has not been used for some time. This can be done with a soft brush and a vacuum cleaner or a

damp cloth and if required a non-abrasive cleaning agent. Do not use corrosive or abrasive substances to clean

the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Danta 1400 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wanders Danta 1400

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info