Bedienungsanleitung Wanders Luna (Seite 23 von 56) (Deutsch, Englisch, Holländisch, Französisch)

533287

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Make your choice from the installation possibilities

shown above. Place the ﬁrst meter of the concentric

pipe on the counterpart on the appliance. You will know

that you placed it properly if you can see the blue rubber

seal ring when looking from above. Keep a distance of at

least 5 cm between the inner side of the concentric pipe

and the wall or the ceiling.

Pay special attention to proper installing when, due to

circumstances, a part of the double-walled pipe system

must be built in.

Exterior wall duct

• Always allow one metre vertical before passing

through the outer wall.

• Determine the location of the gas unit and the exterior

wall duct.

• Make an opening of Ø 155 mm for the wall duct.

• Connect the wall duct with a curve to the mouth of the

appliance. Push them ﬁrmly together and place the

clip bindings. The blue rubber ring ensures sufﬁcient

sealing of the discharge system of the waste gas.

• If the appliance is placed more than 1 metre from

the wall, place the vertical one-metre pipe ﬁrst on

the appliance, then place the curved part, then the

exterior wall duct, and then make them gastight.

Outﬂow on top of the roof

You can place the outﬂow anywhere on the roof, if

necessary with a bend to the ridge of the roof. The roof

duct is supplied with a universally adjustable roof tile for

a tilted roof, or with an adhesive plate for a ﬂat roof.

• Determine the location of the gas unit and the outﬂow

to the roof.

• Make an opening of Ø 155 mm for the roof duct.

• Connect the pipes vertically to the mouth of the

appliance. Push them ﬁrmly together and place the

clip bindings.

• Determine the length of the pipes needed and make

sure that the transfer tile or the universal roof tile is

well ﬁtted to the roof.

• Saw the outer pipe off to measure, and connect the

concentric pipes to the roof duct.

First install the pipe system, and then place the gas

unit

You may also ﬁt the concentric pipe system before

placing the gas unit, but then you must the connection

to the gas unit with a pipe that can be shifted.

Completing the installation

The concentric system is now ﬁtted and the hearth is

installed. To complete the installation, the following

must be carried out:

Opening the door

The gas ﬁreplace must be ignited only when the door

is closed. The door is locked for safety reasons. You can

open the door by turning the screw clockwise. Once the

door is open you can place the ceramic lumber set. The

Domus or Luna Petite can be ﬁred by natural gas only.

Placing the ceramic lumber set

• Fill the bottom of the burner with the supplied

granules. Never use more granules than the supplied

quantity.

• Make sure that you place the ceramic logs exactly

as shown in the illustrations and in the especially

designed recesses of lower logs. Always place the logs

with the sharp or round edges pointing downwards to

avoid covering the ﬂames.

• PLEASE NOTE: Do not touch the glass with your

ﬁngers when closing the door of the gas unit. Finger

marks will burn in the glass.

• Firmly close the door before lighting the hearth.

Step 1

Step 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Luna Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info