Bedienungsanleitung Wanders Pecan Eco (Seite 18 von 64) (Deutsch, Englisch, Holländisch, Französisch)

694507

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

• place 2 relighter blocks in the centre of the grate

• create a pyramid of 8 to 10 pieces of tinder about 3 cm thick and 25 cm long around the relighter blocks

• light the relighter blocks and leave the door slightly ajar

• once the re is burning well and there is no more condensation on the window, close the door

• when the wood-burning stove is hot, close the ue gas valve by pushing the lever (on the left behind the wood-burning

stove) to the right

• do not add any more wood to the wood-burning stove, simply allow the wood-burning stove to go out and cool to room

temperature

• repeat this procedure 3 times

• then repeat the procedure one more time, but this time add 1 kg of wood and allow the wood-burning stove to go out

again

• repeat this procedure 3 times

When you light the Pecan Eco for the rst time, the hearth must still ‘anneal’ and temper itself. The unit has a heat resistant

lacquer which must burn in the stove at temperatures above 400 °Celsius. This will happen during the rst few times of

lighting the stove and temperatures rise to 600 °C. Though this may give an unpleasant smell, it is otherwise harmless. It is

advisable to keep the stove burning with limited fuel for at least 6 hours when lighting the stove for the rst 4 or 5 times. Air

the room well when the stove is burning. Make sure that any cooking hood is not turned on when the stove is burning; a

cooking hood extracts the combustion air that the stove needs.

Some deposit may form on the glass panes of the stove when you ‘anneal’ your hearth. You can easily remove this deposit

with a damp cloth after the stove has cooled down. You can also use some cleansing agent for ceramic rings. Please make sure

you do not leave any nger marks on the clean glass. Finger marks burn into the glass and cannot be removed later.

Newly built house or recently renovated?

It is advisable to wait six weeks before lighting the stove in a newly built house that has recently been

completed, or in a space that has recently been renovated drastically. The walls and ceilings still contain

gases, softeners and moisture from plasterwork or paint. The warm air-streams may discolour the dust

particles in the space, which may stick to walls and ceilings. Even the moisture in the walls and ceilings will

become warm and may cause yellow stains.

HI2 Insides

The HI2 insides were specially developed for WFS and, without giving away too much of our secret

recipe, comprise a mix of special concrete with vermiculite. The heat-reective action of the vermiculite

generates heat build-up in the combustion chamber while the rest of the material stores the heat.

Once combustion is well under way, you will see a perfect re – clean, eco-friendly combustion with a

high heat yield.

The re bricks, weighing in at some 30 kg, initially require thorough heating. The heat in the combustion chamber is key to

ensuring the stove works properly. We therefore advise getting the re going with thinner, more easily combustible wood.

Leave the doors slightly ajar for a quarter of an hour so the re quickly starts to burn ercely.

If you then ensure a red-hot bed of ash for further combustion, this will create decent ames and radiant heat that you can

enjoy for the rest of the evening, while occasionally adding fresh wood.

The heat is stored by the re bricks - known as accumulation - so any fresh logs ignite quickly. This accumulating action means

that the stove continues to give o heat for a long time after the re is extinguished.

The HI2 insides are made using water, so the moisture will have to be heated out of the re bricks during the rst few sessions.

Our advice is to get a really good re going for the rst few hours. At that point, the re will probably not look like it did in the

showroom, but the appearance will improve rapidly after the rst couple of res.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Pecan Eco Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info