Bedienungsanleitung Wanders Peppel (Seite 19 von 48) (Deutsch, Englisch, Holländisch, Französisch)

694508

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

General instructions

The Peppel is tested in accordance with the international EN 13240 standardization, and has an extra additional standardization

for optimally environment-friendly heating devices related to ue gases. The stove can be connected to a ue tube to which

several stoves are connected. The ue tube has a diameter of 150 millimetres.

The heating device must be placed by an acknowledged installer and according to the installation instructions

given below. The national and local rules and regulations for placing and using wood-burning stoves are equally

applicable. WANDERS does not give any guarantee if the Peppel is connected or installed incompletely or

incorrectly.

It is not allowed to place the stove in:

• Arcades and corridors accessible to the public.

• Stairwells, except in buildings with no more than 2 dwellings.

• Spaces where highly ammable or explosive materials are used.

• Spaces where an exhaust system is used or where a mechanical exhaust system is placed, except when the air supply is

taken directly from outside to assure a hazardless combustion.

Preparation

The chimney ue

Before placing the stove you must observe the following points:

• If the stove is connected to an existing chimney, you must rst have the chimney professionally cleaned and checked by

a qualied chimney sweep company. Any cut-o valves or stop valves must be removed.

• The ue tube of the stove must be connected with the chimney without diversions.

• The underpressure in the chimney must be at least 12 Pa or 0.12 mbar.

• The chimney ue must always end up in outlet

area 1 (see drawing)

• At the time of placing the stove, the chimney

ue must be clean, leak-proof and without

obstructions, and must have a diameter of 150

mm.

• Any bends in the ue tube must not exceed 45

degrees.

• Ensure that the chimney tube can discharge the

ue gases adequately, properly and safely.

• The values for calculating the chimney tube is

given in the section on Technical Information,

page 46.

Fire Safety

For reasons of re safety is it important to observe the instructions below before installing the stove.

1. If the oor around the stove is made of combustible material, you must use a oor slab. The oor slab must measure at

least:

- 50 cm from the stove on the front side of the door

- 30 cm from the stove on the sides of the door.

2. Keep at least a distance of 100 cm between the stove and combustible objects such as curtains, wooden objects

(cupboards and paintings) and glass objects. Keep the same distance from the ue tube.

3. Wooden construction parts within the radiation range of the stove (80 cm from the exterior of the stove) must be covered

with reproof material.

4. If the ue tube goes through a ceiling and/or roof that consist of ammable materials, the ceiling and the roof must be

covered with reproof materials all around (about 80 cm). Pay also attention to joisted oor layers and any electric wiring.

5. Keep a distance of at least 50 cm (in all directions) between the stove and supporting steel construction parts.

3 3

A X

X > 23˚

X < 23˚

500 mm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Peppel Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info