Bedienungsanleitung Wanders Solea (Seite 27 von 68) (Deutsch, Englisch, Holländisch, Französisch)

533291

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Installation instructions Solea gas ﬁreplace

Contents

General instructions 27

Placing the concentric channel system 28

Placing possibilities of the pipe system 28

Installing the sealing 30

Completing the installation 30

Technical details 31

General instructions

The Solea gas ﬁreplace is a closed system and must only

be installed by a certiﬁed installer in combination with

WANDERS’ concentric pipe system. Only then will the

Solea be approved according to the European CE standard

for gas appliances. We will not give any guarantees if

the Solea is ﬁtted and/or installed in an incomplete or

improper manner. The pipe system consists of an inner

pipe with a diameter of 80 millimetres and an outer pipe

with a diameter of 150 millimetres.

The appliance may only be installed and connected by

a certiﬁed installer in accordance with the installation

instructions mentioned below. Furthermore, the national

and local rules and regulations on placing and using

closed gas appliances shall be applicable.

Before installing the appliance, the installer must check

whether the information on the type tag of the ﬁreplace

corresponds with the gas type and gas pressure to which

the appliance is connected. If it does not match, you are

not allowed to connect the Solea.

Placing

The gas ﬁreplace can be placed in a crack-free and/or

mechanically ventilated home without difﬁculty. There

is no need for extra ventilation for combustion or for

a smoke and ﬁre vent. Waste gases are discharged by

natural draught via the inner pipe into the open. The

oxygen needed for burning the ﬁre is supplied from

the space between the pipes. This is the reason that no

insulation must be placed between the inner and outer

pipe.

The Solea must not be built into the wall, and must

be placed on a ﬂoor that is solid enough to hold the

appliance. The distance from the Solea to the rear wall

must be at least 10 cm, and there must be a free space

of at least 20 centimetres to the right and left side of the

ﬁreplace.

If you have the turnable Solea, the distance from the gas

hearth to the walls must be at least 20 cm in any turned

position. For ﬁre safety, the distance between the glass

side of the hearth and the wall must never be less than 80

cm in any turned position. Be sure to place the Solea on

a solid ﬂoor plumb under the ﬂue pipe. If the ﬁreplace is

out of plumb with the concentric pipe system, the hearth

cannot be turned.

Insulation

Due to the high temperatures of the exterior walls (up

to approximately 150 °C or 300 °F) it is prohibited to

have or to place any combustible materials close to

the channel system. The entire concentric pipe system

should be encased from the place where it is out of sight

up to the outlet in the exterior wall. Ventilate the encased

concentric pipe system by placing a grid near the ﬂoor

and the ceiling on every ﬂoor. Use universal wall clips

with a diameter of 150 mm for anchoring the concentric

pipe system.

If an existing chimney is used, ﬁrst make sure whether

the chimney is sufﬁciently insulated and with sufﬁcient

diameter to accommodated the concentric pipe system.

If the chimney was previously used as a wood-burning or

coal-ﬁred stove, the chimney must ﬁrst be professionally

cleaned. You must use special WANDERS connecting

sets for connecting a gas hearth to an existing chimney.

Gas connection

• Use a feed pipe with an approved G3/8” stop cock

with coupling. The gas connection of the appliance

is located in the base. The gas pipe can be connected

via the ﬂoor or via the rear side. If you connect the gas

mains to the rear, the bursting disc at the rear of the

base must be broken.

• You must use the 12-mm compression coupling,

which is already mounted on the base.

• De-aerate the supply pipe before tting and fastening

the appliance.

• Avoid tension on the operating valve and pipes to

avoid gas leakage.

• Check if the connection is gastight.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Solea Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wanders Solea

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info