Bedienungsanleitung Wanders Square 40G (Seite 19 von 64) (Deutsch, Englisch, Holländisch, Französisch)

533292

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

When you press both buttons, you will see the ‘transmit’ signal top left on the display.

The hearth has reached its highest or lowest position when the LED of the receiver

starts blinking.

Switching o the pilot ame

The pilot ame is switched o manually. Remove the frame, gently press the ignition

knob (A) and then turn it towards the dot / OFF indiciation.

Lighting the hearth for the rst time

When you light your gas unit for the rst time, the hearth must ‘anneal’. The unit has

a heat resistant lacquer which must still burn in. Though this may give an unpleasant smell, it is otherwise

harmless. It is advisable to turn onto high for about three hours while airing the room well.

Discolouration of walls, ceilings and grates

After lighting your heath the walls, ceilings and grates may show some discolouration. This is caused

by the dust particles that burn in the convection cover. This is a natural process for which WANDERS

cannot be held responsible. To minimize the discolouring we refer to the advice given for atmospheric

hearths. Your installer can give you more information about this.

Some deposit may form on the ceramic glass of the door of the hearth. You can easily remove this deposit with

a damp cloth and if necessary some cleansing agent for ceramic rings when the glass has cooled down. On

page 25 you’ll nd a description on how to open the door and remove the glass.

Avoid nger marks

Avoid leaving any nger marks on the glass after closing the door. Finger marks leave stains that burn

in the glass and cannot be removed later.

When you light your replace for the rst time, the unit calculates how much time is needed to reach the pre-

set temperature. Your hearth will now select the most ecient way to heat the room.

Ensure that the logs are not placed in front of the pilot ame. The gas must be able to stream freely to

the main burner. The main burner is located underneath the log set. See page 20 for placing the log

set properly.

It is advisable to keep the pilot ame burning in heating seasons to prevent condensation and possible

calcication on the inside of the door.

Newly-built house or recently renovated?

It is advisable to wait six weeks before lighting the hearth in a newly-built house that has recently been

delivered, or a space or room that has recently been drastically renovated. The walls and ceilings still

contain gases, softeners and moist from plasterwork or paint. The warm air-streams may discolour

the dust particles in the space which may stick to walls and ceilings. When the moist in the walls and

ceilings warm up, this may also cause yellowish stains.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Square 40G Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wanders Square 40G

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info