Bedienungsanleitung Wanders Square 75 Tunnel Jules (Seite 20 von 60) (Deutsch, Englisch, Holländisch, Französisch)

533614

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Adding wood

Be sure to re-open the ue gas valve before adding wood. This prevents too much ue gasses from entering

the room. After closing the door, you can close the ue-gas valve again.

Lighting the stove for the rst time

Discolouration of walls, ceilings and grates

The walls, ceilings and grates may show some discolouration after lighting your stove. This is caused

by the dust particles that burn in the convection cover. WANDERS cannot be held responsible for this

natural process. To minimize discolouring we refer to the advice given for atmospheric hearths. Your

installer can give you more information about this.

When you light the Square for the rst time, the stove must still ‘anneal’ and temper itself. The unit has a heat

resistant lacquer, which must burn in the stove at temperatures above 400°Celsius. This will happen during

the rst few times of lighting the stove and temperatures rise to 600°C. Though this ‘annealing’ may give an

unpleasant smell, it is otherwise harmless. It is advisable to keep the stove burning with limited fuel for at

least 6 hours when lighting the stove for the rst 4 or 5 times. Air the room well when the stove is burning.

Make sure that any cooking hood is not turned on when the stove is burning; a cooking hood extracts the

combustion air that the stove needs.

Some deposit may form on the glass of the stove when you ‘anneal’ your hearth. You can easily remove this

deposit with a damp cloth after the stove has cooled down. You can also use some cleansing agent for ceramic

rings. Please make sure you do not leave any nger marks on the clean glass. Finger marks burn into the glass

and cannot be removed later.

Newly built house or recently renovated?

It is advisable to wait six weeks before lighting the stove in a newly built house that has recently

been completed, or in a space that has recently been renovated drastically. The walls and ceilings

still contain gases, softeners and moisture from plasterwork or paint. The warm air-streams may

discolour the dust particles in the space, which may stick to walls and ceilings. Even the moisture in

the walls and ceilings will become warm and may cause yellow stains.

Fuel

Wood Drying time

Fir, Poplar 1 year

Lime, Willow, Spruce, Birch, Ash, Alder 1,5 years

Fruit trees, Beech 2 years

Oak 2,5 years

The Square only burns on wood. Do not put more than 3 to 4 kg of fuel in the stove at the time. Always use

clean and cut logs that have suciently dried. Please see the above list for drying times. Wet wood does not

burn well and gives heavy smoke emission. It may blacken the glass of your stove with soot and build up smut

in the ue pipe. This may increase the risk of chimney re.

Fresh, moist wood contains about 50% moisture. Cleaved wood still contains 20% moisture after drying it for

a year and moisture percentage will be decreased to 12 to 15% after drying it for two years. Dry wood gives

nice ames and little or no smoke, and the re will crackle when burning. Wet wood makes a hissing sound,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Square 75 Tunnel Jules Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wanders Square 75 Tunnel Jules

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info