Bedienungsanleitung Wave Spa (Seite 8 von 18) (Englisch)

764856

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

5.3. Drainage and storage

Drainage

Check the stopper on the bottom of the spa and the drain cap.

Unscrew the drain cap.

Remove the stopper on the bottom of the spa. Completely drain all water from the

spa.

4 Once empty, the spa can be cleaned with soap and water.

Storage

5 Press the bubbling button to blow out the water inside the jet holes. Unplug the

pump, remove the filter cartridge from the inner wall of the spa.

Use a towel to wipe off the spa, dry for 24 hours.

Unscrew the valves to deflate the spa.

Fold the spa.

It is recommended to store the spa in its original package in a warm dry place.

5.4. Repair kit

Little holes or punctures can be repaired with the repair kit included and glue can be

adhered to the spa liner.

1. Find the leak.

2. Thoroughly clean the area surrounding the leak.

3. Cut a piece of repair material in round shape, which should be larger than the

damaged area.

4. Apply adhesive to the back of the patch and around the area to be repaired.

5. Put the patch on the damaged area and press down firmly. Allow 12 hours for repair

to dry. After the patch has dried, apply glue around the edges for a complete seal (dry

4 hours). Ensure NO bubbles are left under the patch.

6.1. Troubleshooting

Here are some useful tips to help you to diagnose and rectify common problems

Reference

Inlet – The inlet is where the filter is attached

Outlet – The water outlet is directly above of the filter and is where the hot water

is recirculated back into the spa from the heater unit.

Problem Cause Solution

Control panel

screen does not

operate

Check power source

Power failure

Reset the RCD plug / Check if the wiring system is adapted to

the power of the pump unit (1540W)

Contact service centre for service if it does not reset

SPA pump does not

heat properly

Temperature set is too low

Set to a higher temperature

Filter Cartridge is dirty

Clean or Replace the cartridge (see chapter 5.2)

Too low water level Fill water to minimum water level

Heating element defective Contact service centre

Bubble system

does not work

Pump is overheating Cut off the power and wait until the pump has cooled.

Auto shut-down feature (30min) is

activated

Press the bubble button to reactivate

Malfunction of the pump unit Contact service centre if it does not reset

Water filtration does

not work

Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)

Inlet and outlet blocked Clean the inlet and outlet

Air inside the pump

Fill water to minimum water level

Malfunction of the pump unit

Contact service centre if it does not reset

Pump leakage

Adaptor seal in wrong position

Replace the seal in the right position

Water leakage from pump body

Check the pump body, Contact service centre

Spa leakage

Spa is torn or punctured

Use provided repair kit (see chapter 5.4)

Water is not clean

Insufficient filtering time Filters must be changed once a week

Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)

Spa filled water quality Change the spa water completely

Improper water treatment Refer to the chemical manufacturer’s instructions

6. TROUBLE SHOOTING

12 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wave Spa Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info