Bedienungsanleitung Webasto Air Top 2000 ST (Seite 2 von 8) (Englisch)

802145

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

8. In the event of long-lasting heavy smoke development, unusual combustion noises or a

smell of fuel or if the heater suffers continuous fault cut-outs with error messages

(flashing code), it must be shut down by removing the fuse and must not be reused until

it has been inspected by Webasto-trained personnel.

9. Wherever inflammable vapours or dust may form (for example in the vicinity of

fuel, carbon, wood dust or cereal stores or the like), the heater must be switched

off as a result of the risk of explosion.

10. The heat transfer unit on air heaters is exposed to very high thermal stress and

must be replaced by a genuine Webasto spare part ten years after it is used for

the first time.

If exhaust lines pass through areas used by personnel, they must also be replaced

by genuine spare parts after ten years.

11. The fuel specified by the vehicle manufacturer is suitable for use in the Air Top 2000 ST

B (petrol EN228).

The diesel fuel specified by the vehicle manufacturer is suitable for use in the Air Top 2000

ST D (diesel EN590).

We know of no negative influences due to additives.

If fuel is extracted from the vehicle’s tank, follow the additive instructions issued by the

vehicle manufacturer.

If you change to low-temperature fuel, the heater must be operated for approx. 15

minutes so that the fuel system is filled with the new fuel.

12. The temperature in the area around the heater must not exceed 85 °C (storage

temperature). If the temperature exceeds this level there is a risk of permanent damage

to the electronics systems.

13. Non-compliance with the installation instructions and the warnings contained therein will

lead to the exclusion of all liability by Webasto. The same applies if repairs are carried out

incorrectly or with the use of parts other than genuine spare parts. This will result in the

invalidation of the type approval for the heater unit, and therefore of its homologation/

ECE type licence.

14. Keep the hot air inlet and hot air outlet free of dirt and foreign bodies. Soiled or blocked

hot air lines may cause overheating, and therefore result in the overheating cut-out

tripping.

15. To prevent mechanical parts seizing, the heater should be operated for approx. 10

minutes every four weeks.

16. Do not stand on the heater and do not place any heavy items on the heater or throw

items at the heater.

17. Do not place any items of clothing, textiles or similar materials over the heater or in front

of the hot air inlet and the hot air outlet.

18. The current of hot air in the heater must not be restricted or blocked by highly

inflammable substances or materials such as rags, cleaning wool, etc.

19. The heater must not be cleaned with a high pressure cleaner.

9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 2 Thursday, June 6, 2013 8:25 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Air Top 2000 ST Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Air Top 2000 ST

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info