Bedienungsanleitung Webasto Air Top Evo 55 (Seite 6 von 11) (Englisch)

802206

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

9 | Service signal

6 / 11 9030680B OI Air Top Evo 40 _ 55 EN

lOn control elements without a display (analogue), the fault

code is indicated in the form of a flash pulse. The pulses are

short or long. The number of long pulses corresponds to

the number of the fault code. F00 is just rapid flashing.

lIn event of an error occurring, check the fuse and plug con-

nectors.

lIf the fault cannot be rectified by the measure described,

contact your Webasto service workshop.

NOTE

Independent maintenance work, particularly using flam-

mable gases or liquids such as accelerators, is forbid-

den.

Code Hex code Possible cause Action

F01 H02 / H82 /

H83

No start Switching the

heater off and on

F02 H03 Flame goes out dur-

ing operation

F03 H04 / H84 On-board power

supply too low / un-

dervoltage or over-

voltage

lCharge the

vehicle battery.

lSwitching the

heater off and

on.

F10 H5B / H5C /

H06 / H17

Heater overheats lCheck the cold

and hot air

lines for free

passage.

lSwitch off

heater.

lAllow the

heater to cool

down.

lSwitch on the

heater.

- - On vehicles for trans-

porting hazardous

goods: Vehicle en-

gine switched off /

pumping device in

operation

lMake sure that

the pumping

device is out of

operation.

lWait until the

heater switches

to fault lock-

out.

lSwitch the

heater off and

on via the con-

trol element.

- - Heater emits black smoke

- - Combustion air and

exhaust gas guiding

blocked

Check combustion

air and exhaust gas

routing for free pas-

sage.

In case of any other error messages not listed, contact

the Webasto service workshop.

9 Service signal

In the event of service information, the service signal is shown

via the control element when the heater is switched on.

lIn the case of the MultiControl / SmartControl control ele-

ment, a service symbol is displayed.

lOn control elements without display: indicator lamp flashes

for 60s: on for 1 s, off for 1 s.

uHave the heater checked by a professional.

The heater can continue to be used with limited operation.

10 Maintenance

lPut the heater into operation every 4 weeks in order to pre-

vent mechanical parts from seizing.

lAt the beginning of the heating period, have the heater

checked by a professional.

11 Disposal

The Air Top Evo 40 | 55 must not be disposed of in domestic

waste.

Observe the regional regulations for disposal of electronic

products.

12 Service and customer

services

The device is registered during installation by the Webasto ser-

vice workshop. You will receive the registration document.

Pass the registration document on to the next owner or user of

the device.

Do you have any technical questions or problem with the

device?

National phone numbers of our representatives are provided

on:

https://www.webasto-group.com/en/the-company/loca-

tions-worldwide/

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Air Top Evo 55 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Air Top Evo 55

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info