Bedienungsanleitung Webasto Dual Top Evo 6 (Seite 12 von 25) (Englisch)

802467

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

Operating Instructions Dual Top Evo 6

4.3 Frost

There are several features that protect the water supply system against frost.

• Drain water contents manually when there is risk of frost and when storing the

vehicle for a longer period.

See paragraph 4.3.1: "Draining the boiler manually".

• The boiler is drained automatically in case you forgot to drain manually.

See paragraph 4.3.2: "Draining the boiler automatically".

• In case you don’t want to drain the water supply system and you don’t heat the

interior of the vehicle, you can select the frost protection mode.

See paragraph 4.3.3: "Frost protection mode".

4.3.1 Draining the boiler manually

Drain water contents manually when there is risk of frost and when storing the vehicle

for a longer period.

1 Interrupt power for vehicle system water pump (main switch or pump switch,

depending on instructions of the vehicle manufacturer).

2 Open hot water taps in kitchen, bathroom, shower, etc. (set pre-selecting mixing

taps or single-lever valves to "hot").

3 The electrical safety/drain valve is opened by turning and holding the mode

selector knob (A) against the spring force in the position drain boiler (6) for at

least 5 seconds.

Then, release the knob.

The electrical safety/drainage valve will open for approx. 90 minutes.

During drainage, all green icons on the control panel, as well as the red indicator

on the mode selector knob (A), are blinking.

The boiler content is now discharged to the outside through the electrical safety/

drainage valve.

Place a container beneath the outlet to check whether the water in the boiler has

completely drained away (approx. 10 litres!).

NOTE

Any kind of water from the vehicle has to be discharged at a proper disposal facility.

NOTE

Drainage can be stopped by again moving mode selector knob (A) to drainage mode

(6) for at least 5 seconds and then releasing the knob.

NOTE

Avoid the formation of micro-organisms in the lines and in the boiler during storage and

make sure that the water supply system is completely drained. To do this, open all water

valves, connect an air pressure of approx. 2 bar to the hot water line and leave it

connected until the residual water is completely drained off.

4.3.2 Draining the boiler automatically

The electrical safety/drainage valve is opened electrically.

If the water temperature at the electrical safety/drainage valve is less than 6 °C, the

boiler water contents may discharge automatically.

This function is active when:

• the appliance is switched "OFF";

• in winter mode (heating without hot water production) during a period when there

is no heating action in the heater (e.g.: selected interior temperature is reached, low

outside temperature);

• if battery power is too low;

• there is a failure!

NOTE

Note that it only works when a 12 V power supply is available!

During drainage, all green icons on the control panel, as well as the red indicator on the

mode selector knob (A), are blinking.

After approx. 90 min, the electrical safety/drainage valve will be closed again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Dual Top Evo 6 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Dual Top Evo 6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info