Bedienungsanleitung Webasto Dual Top Evo 6 (Seite 18 von 25) (Englisch)

802467

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

Maintenance Dual Top Evo 6

For disinfection use a solution of Sodium Hypochlorite (NaOCl), dilution 5 %,

30 to 40 ºC (e.g. Certisil

, Puriclean).

Other products can harm your health and/or the Dual Top Evo 6.

Carefully follow all instructions of the NaOCl supplier.

Carefully follow all instructions of the vehicle manufacturer.

1 Drain all water contents. See paragraph 4.3.1: "Draining the boiler manually".

2 Close all water taps.

3 Fill entire water supply system with NaOCl.

4 Select “Summer mode 40°C” to make sure the electrical safety/drainage valve

does not open.

5 Make sure that the boiler is filled with NaOCl.

6 Open water taps in kitchen, bathroom, shower, etc. (set pre-selecting mixing taps

or single-lever valves to "hot").

Leave the taps open until the air has been completely forced out of the Dual Top

Evo 6, it is filled with NaOCl and NaOCl flows out of the taps. Then close the taps.

Open the taps one by one, not all at the same time.

7 Leave it on for 1 to 2 hours.

8 Drain all NaOCl contents.

9 Repeat the described procedure (step 1 to 8) with drinking water 1 or 2 times.

No need to leave it on for 1 to 2 hours.

10 Drain all water contents.

11 Fill entire water supply system with drinking water. See chapter 5: "Filling the

boiler".

7.2 Descaling

Depending on the hardness of the water, used for heating in the Dual Top Evo 6, scaling

and lime deposits can form in the coolant hoses and the boiler. In order not to restrict

the water quality and the heater efficiency, it is advisable to conduct descaling regularly

depending on the water quality.

Use common household products, such as "Kettle Klear" or a wine vinegar-water

mixture with a ratio of 1:2 for descaling.

Other products can harm your health and/or the Dual Top Evo 6.

1 Drain all water contents. See paragraph 4.3.1: "Draining the boiler manually".

2 Close all water taps.

3 Fill the entire water supply system with wine vinegar-water mixture.

4 Select “Summer mode 40°C” to make sure the electrical safety/drainage valve

does not open.

5 Make sure that the boiler contains the mixture.

6 Open water taps in kitchen, bathroom, shower, etc. (set pre-selecting mixing taps

or single-lever valves to "hot"). Leave the water taps open until the entire air has

been pressed out of the Dual Top Evo 6, they are filled with the wine vinegar-

water mixture and it flows out of the water taps. Then close the taps.

Open the taps one by one, not all at the same time.

7 Leave it on for 1 to 2 hours and wait for reaction phase.

8 Check whether the scale deposits have completely dissolved in the vinegar water.

If not, allow the heater to run for another 30 minutes and then completely drain

off the wine vinegar-water mixture.

9 Flush the water supply system with drinking water until it no longer smells like

vinegar.

10 Then fill the boiler with fresh drinking water again. See chapter 5: "Filling the

boiler".

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Dual Top Evo 6 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Dual Top Evo 6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info