Bedienungsanleitung Webasto Next (Seite 12 von 23) (Englisch)

802117

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

9 | WebUI

12 / 23 5111232C OI-II Webasto Next_EN

D4 0= no unbalance load limit for single-phase charging.

1= unbalance load limit at 16A and D1-D3 > 20A

(for CH and AT).

D5 0= no unbalance load limit for single-phase charging.

1= unbalance load limit at 20A and D1-D3 > 25A (for D).

D6 1= TN/TT system.

0= IT system (only single-phase connection possible).

WARNING

Only a qualified electrician may adjust the settings in

the Webasto Charger Setup app.

8.8 Initial start-up

8.8.1 Safety check

Document the results of the checks and measurements carried

out during initial start-up corresponding to the applicable in-

stallation requirements and standards.

The Webasto Charger Setup app supports you with checks dur-

ing initial start-up.

The local regulations relating to operation, installation and en-

vironmental protection also apply.

8.8.2 Start-up procedure

1. Remove material residues from the connection area.

2. Check that every screw is correctly tightened and every

clamp is correctly engaged.

3. Fit the lower cover.

4. Secure the bottom cover with the mounting screws; care-

fully tighten the mounting screws to the stop. See Fig. 5.

5. Switch on power supply.

– Start sequence is activated (duration up to 60 seconds).

– White chase light running up and down. See Fig. 11, op-

erating status N2.

WEM000062A

Fig.11

Check initial start-up and record the measured values in the

test log. The Webasto Charger Setup app can support you

in carrying out and documenting this. An EV simulator is

used for the measurement at the charging coupling.

Simulate and test the individual operating and protection

functions with the EV simulator.

Connect the charging cable to the vehicle.

– The LED changes from green (N3) to pulsing blue

(N4). See Fig. 22.

9 WebUI

The WebUI is a graphical user interface which a user can use to

interact with the system via a web browser.

The WebUI can be accessed in the browser in the following

ways:

lWith a WLAN connection to the hotspot in the wall box,

the WebUI can be accessed in the browser at the following

IP address: 172.20.0.1

lWith a WLAN or LAN connection to the router, the WebUI

can be accessed in the browser at the following IP ad-

dresses:

– YYYYY (YYYYY --> IP address that has been assigned to

the wall box by the router)

– https://NEXT-WSXXXXXX (WSXXXXXX - Serial No.: see

type plate)

IP-Adresse: 172.20.0.1 IP-Adresse: - https://WSNEXT-XXXXX

- Wallbox IP-Adresse

HEMS / Smart

Meter

Fig.12

lUser name: admin

lPassword: master password (see installation documenta-

tion)

172.20.0.1 oder YYYYY oder https://NEXT-WSXXXXX

admin

Masterpasswort

Fig.13

9.1 Settings in the WebUI for DLM

The configuration of the DLM in the WebUI will be described

below. For more information see chapter10, "Dynamic Load

Management – Stand-alone mode (DLM)" on page 13.

1. Select the HEMS tab in the WebUI.

2. Enable expert mode.

3. Under Mode, select DLM with external meter activated.

4. Under Connection type select LAN or WLAN.

5. Under Safe current L1/L2/L3 select the maximum possible

current when there is no connection to the smart meter.

6. Under External Meter IP enter the IP address for the

meter assigned by the router.

7. Under External Meter Module select the meter model.

8. Under External Meter Position select including wallbox

or excluding wallbox.

9. Under Recalculation interval enter 30.

10. Under Current limit external meter enter the maximum

current.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Next Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Next

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info