Bedienungsanleitung Webasto Next (Seite 17 von 23) (Englisch)

802117

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

Operation | 14

5111232C OI-II Webasto Next_EN 17 / 23

14.2.2 LED fault list

WCH000074A

Fig.23

Fault list Description

F1 LED lights up green, there is additionally a yellow pulse:

The charging station has become hot and charges the

vehicle with reduced power. After a cool-down phase

the charging station continues the normal charging

cycle.

F2 LED is yellow and an acoustic signal sounds for 0.5s:

Overtemperature. The charging function has been inter-

rupted and after a cool-down phase the charging station

continues the normal charging cycle.

F3 LED lights up green, there is additionally a red pulse and

an acoustic signal sounds for 0.5s:

There is a fault in the power connection to the charging

station, phase monitoring is active, the power supply is

outside the valid range of 200V to 260V.

A qualified electrician should check the phase

sequence (clockwise phase sequence required),

network frequency, DIP switch setting and protective

conductor resistance.

F4 LED pulses red for 1 s at 2 s intervals and an acoustic sig-

nal sounds for 0.5s, and then for 5s following a pause

of 1s:

There is a fault in the vehicle.

Re-connect the vehicle.

F5 LED pulses red for 0.5s at 0.5s and 3s intervals. An

acoustic signal sounds for 0.5s:

There is an internal fault with an extra-low voltage

(e.g. 12 V).

Checking by an authorised electrician.

F6 LED is red and an acoustic signal sounds for 0.5s. Then,

after a pause of 1s, the acoustic signal sounds for 5s:

There is a problem in the voltage or system monitoring.

Checking by an authorised electrician.

Danger of fatal electric shock.

Switch off and secure the power supply to the charging

station. Only then unplug the cable from the vehicle.

Table4: Fault indicators and troubleshooting

14.3 Start charging

In what follows, "Free charging enabled" describes the beha-

viour specified during installation. For "Free charging disabled",

see the information from chapter14.5, "Scan & Charge locking

function" on page 18.

WCH000006A

Fig.24

NOTE

Always take into account the vehicle requirements be-

fore charging a vehicle.

NOTE

Park the vehicle for charging such as to avoid strain in

the charging cable. See Fig. 24

Action Description

Connect the charging

coupling to the vehicle.

Charging station performs system

and connection tests.

At the start of charging, the LED

strip which was initially green

starts to pulse blue. If the vehicle is

not ready for charging (e.g. the

battery is full), a blue chase light

runs up and down.

14.4 Stop charging

The vehicle has stopped the charging cycle automatically:

Action Description

Unlock the car if necessary.

Unplug the charging coup-ling

from the vehicle.

Lock charging coupling in the

holder of the charging station.

LED: Blue chase light running up

and down. Vehicle is connected,

not charging.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Next Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Next

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info