Bedienungsanleitung Weber q320 (Seite 24 von 64) (Englisch, Französisch)

328030

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

OPERATING INSTRUCTIONS

LIGHTING

Summary lighting instructions are posted on the cart leg under the control knobs (L).

ƽ DANGER

Failure to open the lid while igniting the barbecue’s burners,

or not waiting 5 minutes to allow the gas to clear if the

barbecue does not light, may result in an explosive flame-up

which can cause serious bodily injury or death.

1) Open the lid.

2) Make sure all burner control knobs are turned OFF. (Push control knob in and turn

clockwise to ensure that it is in the OFF position.)

ƽ WARNING: The burner control knobs must be in the OFF

position before turning on the liquid propane cylinder tank

valve. If they are not in the OFF position, when you turn on

the LP cylinder valve, the “excess gas flow control” feature

will activate, limiting the flow of gas from the LP cylinder. If

this should occur, turn OFF the LP cylinder valve and burner

control knobs. Start over.

ƽ WARNING: Check hose before each use of barbecue for

nicks, cracking, abrasions or cuts. If the hose is found to

be damaged in any way, do not use the barbecue. Replace

using only Weber

authorized replacement hose. Contact

the Customer Service Representative in your area using the

contact information on our web site. Log onto

www.weber.com

IGNITION SYSTEM- Q300

Note - The ignition system ignites the burners with a spark from the igniter electrode

inside the ignition chamber. You generate the energy for the spark by pushing the

ignition button until it clicks.

3) Turn the gas on by slowly turning the cylinder valve counterclockwise. Wait 60

seconds.

ƽ WARNING: Do not lean over the open barbecue when

lighting the barbecue.

4) Select the Outside burner, push control knob in and turn to START/HI.

5a) Q300- Push the ignition button, so that it clicks. Repeat if necessary.

5b) Q320- Push the electronic ignition button several times. You will hear it spark.

6) Check that the burner is lit by looking down through the cooking grate. You should

see a flame.

ƽ WARNING: If the burner does not light, turn the burner

control knob to OFF and wait 5 minutes to let the gas clear

before you try again or try to light with a match.

7) After the Outside burner is lit you can turn on the Inside burner. The Inside burner

is ignited from the Outside burner.

TO EXTINGUISH

Push in and turn each burner control knob clockwise to the OFF position. Turn gas

supply OFF at the source.

1).

2). 4).

6).

L).

3).

5).

ƽ DANGER:

When the “excess gas flow control” feature is activated,

a small amount of gas is still flowing to the burners. After

turning OFF the cylinder valve, wait at least 5 minutes for the

gas to clear before attempting to light the barbecue. Failure

to do so may result in an explosive flame-up, which can

cause serious bodily injury or death.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber q320 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber q320

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info