Bedienungsanleitung Weber summit e 420 (Seite 16 von 84) (Englisch)

328039

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

2 4

m DANGER

When the “excess gas flow control” feature is activated,

a small amount of gas is still flowing to the burners. After

turning off the cylinder and burner control knobs, wait at

least five minutes for the gas to clear before attempting to

light the grill. Failure to do so may result in an explosive

flare-up, which can cause serious bodily injury or death.

mAIN bURNER IGNITIoN & USAGE

MAIN BURNER IGNITION

Summary lighting instructions are inside the left-hand cabinet door.

m DANGER

Failure to open the lid while igniting the barbecue’s burners,

or not waiting five minutes to allow the gas to clear if the

barbecue does not light, may result in an explosive flare-up

which can cause serious bodily injury or death.

Main Burner Snap Ignition

Note: Each control knob snap igniter creates a spark from the igniter electrode to the

burner lighting tube. You generate the energy for the spark by pushing in the control

knob and turning to START/HI. This will ignite each individual burner.

m WARNING: Check hose before each use of barbecue for

nicks, cracking, abrasions or cuts. If the hose is found to

be damaged in any way, do not use the barbecue. Replace

using only Weber

authorized replacement hose. Contact

the Customer Service Representative in your area using the

contact information on our web site.

Log onto www.weber.com

A) Open the lid (1).

B) Make sure all burner control knobs are turned off (2). (Push control knob in and turn

clockwise to ensure that it is in the OFF position.)

m WARNING: The burner control knobs must be in the OFF

position before turning on the liquid propane cylinder tank

valve. If they are not in the OFF position, when you turn on

the LP cylinder valve, the “excess gas flow control” feature

will activate, limiting the flow of gas from the LP cylinder. If

this should occur, turn off the LP cylinder valve and burner

control knobs. Start over.

C) Turn the cylinder on by turning the cylinder valve counterclockwise (3).

m WARNING: Do not lean over the open barbecue.

D) Push the control knob in and turn to START/HI until you hear the igniter snap (4),

continue to hold control knob in for two seconds. This action will spark the igniter,

the burner lighting tube and then main burner.

E) Check that the burner is lit by looking through the cooking grates (5). You should

see a flame. If burner does not light on first try, push control knob in and turn to OFF.

Repeat lighting procedure a second time.

m WARNING: If the burner still does not light, turn the burner

control knob to OFF and wait five minutes to let the gas

clear before you try again or try to light with a match.

◆

TO EXTINGUISH

Push in and turn each burner control knob clockwise to OFF position. Turn gas supply off

at the source.

◆

2 4

The grill illustrated may

have slight differences

than the model purchased.

ARRÊTÉ

APAGADO

OFF START/HI MEDIUM LOW

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber summit e 420 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber summit e 420

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info