Bedienungsanleitung Weber Summit E-670 (Seite 26 von 36) (Englisch)

579168

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ROTISSERIE BURNER IGNITION & USAGE

ROTISSERIE BURNER IGNITION

Rotisserie Burner Snap Ignition

NOTE: Each control knob snap igniter creates a spark from the igniter electrode to the

burner lighting tube. You generate the energy for the spark by pushing in the control knob

and turning to START/HI. This will ignite each individual burner.

m ATTENTION: READ BEFORE LIGHTING

ROTISSERIE BURNER

After a period of non-use, before lighting the Rotisserie Burner, a

few seconds must pass for the gas supply line to fill.

When using the snap igniter you will see a flash of flames

moving from left to right across the Rotisserie Burner surface,

the Rotisserie Burner is not lit until the entire ceramic surface

is aflame.

At this point, start a count of twenty seconds before releasing

the Rotisserie Burner control knob.

The Rotisserie Burner surface will glow red once the burner is

fully ignited.

m DANGER

Failure to open the lid while igniting the grill, or not waiting five

minutes to allow the gas to clear if the grill does not light, may

result in an explosive flare-up, which can cause serious bodily

injury or death.

m CAUTION: The Rotisserie Burner flame may be difficult to see

on a bright sunny day.

m WARNING: Always check hose before using grill for nicks,

cracking, abrasions or cuts. If the hose is found to be damaged

in any way, do not use the grill. Replace using only a Weber

authorised replacement hose. Contact the Customer Service

Representative in your area using the contact information on

our web site.

Log onto www.weber.com.

A) Open the lid (1).

B) Remove the warming rack and the cooking grates from the cookbox (2).

C) Make sure all burner control knobs are turned off (3). (Push control knob in and

turn clockwise to ensure that it is in the OFF position.)

m WARNING: The burner control knobs must be in the OFF

position before turning on the liquid propane cylinder tank

valve.

D) Turn on the cylinder valve using one of the appropriate options based on your

cylinder and regulator type (4).

m WARNING: Do not lean over the open grill.

E) Push the control knob in and turn to START/HI. This action will spark the igniter

and light the Rotisserie Burner. Continue to use the snap igniter until the Rotisserie

Burner has ignited. Continue to hold the control knob down for twenty seconds after

the burner has ignited. Release the control knob (5).

F) Check that the burner is lit by looking for the rotisserie burner to glow red (6).

m WARNING: If the rotisserie burner does not light, turn the

burner control knob to OFF and wait five minutes to let the gas

clear before you try again or try to light with a match.

NOTE: When using the rotisserie with the lid closed, only light two of the main burners on

each side of the food (refer to COOKING METHODS-INDIRECT COOKING). Check your food

periodically to prevent overcooking on the outside. Turn off the rotisserie burner once the

food has browned to the desired colour. Finish cooking on indirect heat.

◆

TO EXTINGUISH

Push in and turn the rotisserie burner control knob clockwise to OFF position. Turn gas

supply off at the source.

◆

3 5

OFF START/HI LOW

The grills illustrated in this

Owner’s Guide may vary slightly

from the model purchased.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber Summit E-670 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber Summit E-670

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info