Bedienungsanleitung Weber summit s 450 (Seite 18 von 76) (Englisch)

328040

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

WWW.WEBER.COM

OPERATING INSTRUCTIONS

USING THE SMOKER

The smoker uses presoaked wood chips. For best results with faster cooking foods like

steaks, burgers and chops, etc., we recommend using finer wood chips because they

ignite and create smoke faster. For longer cooking foods such as roasts, chicken and

turkeys, etc., we recommend using larger wood chunks because they ignite slowly and

provide smoke for a longer period of time. As you gain experience in using your smoker,

we encourage you to experiment with different combinations of wood chips and chunks

to find the smoke flavor that best suits your taste.

TO USE THE SMOKER

As a starting point, soak wood chips in water for at least 30 minutes before using. (Wet

wood will produce more smoke flavor.) Place a handful of wood chips or a few larger

chunks in the bottom of the smoker body (1). As you gain experience in smoking,

increase or decrease the amount of wood to suit your taste.

Note: Always grill with the lid closed to allow the smoke to fully penetrate the food.

Light the smoker burner by following the instructions for Lighting The Smoker Burner

After wood starts to smolder turn control knob to “LOW”.

Smoke will start in approximately 10 minutes and last as long as 45 minutes. If you

require more smoke flavor, refill the smoker with wood chips and /or chunks. Keep the

lid of the grill closed while cooking.

Note: After refilling smoker, smoke will take about 10 to 15 minutes to start again.

The smoker may be used to enhance meat, poultry and fish recipes. Cook with the lid

down according to the times indicated in charts or recipes.

ƽ DANGER

Do not use any flammable fluid in the smoker to ignite the

wood. This will cause serious bodily injury.

CLEANING THE SMOKER

Before each use, empty the smoker of ash to allow proper air flow.

Note: Smoking will leave a “smoke” residue on the surface of the smoker. This residue

cannot be removed and will not affect the function of the smoker. To a lesser degree a

“smoke” residue will accumulate on the inside of your gas grill. This residue need not

be removed and will not adversely affect the function of your gas grill.

E/S-450

LIGHTING THE SMOKER BURNER

SMOKER BURNER SNAP IGNITION

Note: The control knob snap igniter creates a spark from the igniter electrode to the

burner lighting tube. You generate the energy for the spark by pushing in the control

knob and turning to “START/HI”. This will ignite the smoker burner.

ƽ WARNING: Check hose before each use of grill for nicks,

cracking, abrasions or cuts. If the hose is found to be

damaged in any way, do not use the grill. Replace using only

Weber

authorized replacement hose. Contact the Customer

Service Representative in your area using the contact

information on our web site. Log onto www.weber.com

1) Open the grill lid.

2) Open smoker box lid.

3) Fill smoker with water soaked wood chunks or chips.

4) Make sure that all burner control knobs not being used are turned to “OFF”. (Push

control knob in and turn clockwise to ensure that it is in the “OFF” position).

5) Turn on the gas at source.

ƽ WARNING: Do not lean over the open grill while lighting.

6) Push the control knob in and turn to “START/HI” until you hear the igniter snap -

continue to hold control knob in for two seconds. This action will spark the igniter,

the burner lighting tube and then main burner.

7) Check that the burner is lit by looking through the cooking grates. You should see

a flame. If burner does not light on first try, push control knob in and turn to OFF.

Repeat lighting procedure a second time

E/S-450

* The grill illustrated may have slight

differences than the model purchased.

ƽ DANGER

Failure to open the lid while igniting the grill, or not waiting

5 minutes to allow the gas to clear if the grill does not light,

may result in an explosive flare-up which can cause serious

bodily injury or death.

ƽ DANGER

If the smoker burner does not light, turn the burner control

knob to “OFF” and wait 5 minutes to let the gas clear before

attempting to light.

8) Close smoker cover after wood starts to smolder and turn control knob to “LOW”.

TO EXTINGUISH

Push in and turn each burner control knob clockwise to “OFF” position. Turn gas supply

off at the source.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber summit s 450 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber summit s 450

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info