Bedienungsanleitung Weber summit s 450 (Seite 22 von 76) (Englisch)

328040

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

WWW.WEBER.COM

LIGHTING THE ROTISSERIE BURNER

ROTISSERIE BURNER SNAP IGNITION

Note: Each control knob snap igniter creates a spark from the igniter electrode to the

burner lighting tube. You generate the energy for the spark by pushing in the control

knob and turning to “START/HI”. This will ignite each individual burner.

ƽ ATTENTION: READ BEFORE

LIGHTING ROTISSERIE BURNER

After a period of non-use, before lighting the Rotisserie

Burner, a few seconds must pass for the gas supply line to

fill.

When using the snap igniter you will see a flash of flames

moving from left to right across the Rotisserie Burner

surface, the Rotisserie Burner is not lit until the entire

ceramic surface is aflame.

At this point, start a count of 20 seconds before releasing the

Rotisserie Burner control knob.

The Rotisserie Burner surface will glow red once the burner

is fully ignited.

ƽ CAUTION: The Rotisserie Burner flame may be difficult to

see on a bright sunny day.

ƽ WARNING: Check hose before each use of grill for nicks,

cracking, abrasions or cuts. If the hose is found to be

damaged in any way, do not use the grill. Replace using

only a Weber

authorized replacement hose. Contact the

Customer Service Representative in your area using the

contact information on our web site.

Log onto www.weber.com

1) Open the lid.

2) Remove the warming rack and the cooking grates from the cookbox.

3) Make sure all burner control knobs are turned to “OFF”. (Push control knob in and

turn clockwise to ensure that it is in the “OFF” position.)

4) Turn on the gas at source.

ƽ WARNING: Do not lean over the open grill.

5) Push the control knob in and turn to “START/HI”. This action will spark the

igniter and light the Rotisserie Burner. Continue to use the snap igniter until the

Rotisserie Burner has ignited. Release the control knob.

6) Check that the burner is lit by looking for the rotisserie burner to glow red.

E/S-450

* The grill illustrated may have

slight differences than the

model purchased.

ƽ WARNING: If the rotisserie burner does not light, turn the

burner control knob to “OFF” and wait 5 minutes to let the

gas clear before you try again or try to light with a match.

Note: When using the rotisserie with the lid closed, only light two of the main burners

on each side of the food (See Grilling Methods-Indirect Cooking). Check your food

periodically to prevent over cooking on the outside. Turn off the rotisserie burner once

the food has browned to the desired color. Finish cooking on Indirect heat.

TO EXTINGUISH

Push in and turn each burner control knob clockwise to “OFF” position. Turn gas supply

off at the source.

ƽ DANGER

Failure to open the lid while igniting the grill, or not waiting

5 minutes to allow the gas to clear if the grill does not light,

may result in an explosive flare-up which can cause serious

bodily injury or death.

OPERATING INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber summit s 450 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber summit s 450

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info