44
Problem
Burner does not light.
Burner does not light or burner has a small
flickering flame.
Burner does not light.
Check
Did you hold the burner control
knob down and hold down for 10
seconds until after burner ignited?
The excess flow safety device,
which is part of the grill to cylinder
connection, may have activated.
Is the igniter sparking
Cure
Try to relight burner by
holding burner control knob
down and continue holding
down until 10 seconds after
burner has ignited.
Too reset the excess flow
safety device turn all burner
control knobs and the
cylinder valve OFF.
Disconnect the regulator from
the cylinder. Turn burner
control knobs to HIGH. Wait
at least 1 minute. Turn burner
control knobs OFF.
Reconnect the regulator to
the cylinder. Turn cylinder
valve on slowly. Refer to
“Lighting Instructions”
Replace battery in igniter
button module.
Reseat burner ring.
WARNING: Before attempting any troubleshooting
steps, all gas controls and supply valves should be in
the OFF position.
ROTISSERIE BURNER TROUBLESHOOTING
