Bedienungsanleitung Wellis Serenis (Seite 2 von 80) (Deutsch, Englisch, Französisch)

784897

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

EN Installation Guide

Please read the following directions carefully.

This type of sauna use embedded latch locking system fixed together, the installation

requires 2~3 persons. Put on gloves and pay more attention not to hurt yourself during the

installation.

Minimum ceiling height required for the installation and operation of the sauna: 230 cm.

To assure the installation smoothly and use well in future, please install each step

carefully and make sure placement and connection of each panel balanced and tightly.

Electrical Requirements

Each sauna will require an exclusive circuit when plugged in an outlet. A exclusive

circuit requires that no other appliance to share the outlet/circuit with the sauna. Failure

to comply with this requirement may cause electrical interruption and diminished

performance. The electrical connection point is always located in the right front corner of

the sauna. (Figure 12)

Before installing the sauna, it is necessary to install a cable of suitable length (taking into

account the dimensions of the sauna).

Minimum cross-section of cables:

– for 1 phase: 3x4 mm2 (in the case of 4.5 kW heating)

– for 3 phases: 5x4 mm2 (in the case of 8 and 9 kW heating)

(For 4.5 kW heaters, we provide a 40A leakage protector; for 8 and 9 kW heaters we

provide a 63A leakage protector.)

Please make sure the sauna is properly grounded. Serious injury may result if proper

electrical requirements are not met.

We recommend that you seek the assistance of a qualified electrician to wire your sauna

properly, in order to avoid electrical risks, especially regarding high-power saunas.

The sauna stove must always be placed in the corner, to the right of the glass door. Make

sure that the minimum required distances are observed (see the sauna stove instructions

or sauna stove data plate.)

Package Information

Traditional saunas (with a front panel full glass) are packed in 6 cartons (Package 1 for

top and floor panel, benches and spare parts. Package 2 for back panel. Package 3 for

left and side panel. Package 4 for glass. The extra two package stove and stone)

Each sauna has a sole serial number which was shown on each package carton of sauna

cabin. Please make sure the cartons you get are with a same serial number, so that you

can assemble the unit well.

Please make sure that when you open the package cartons keep face up. Please be very

careful when opening boxes, due to fragile parts and glass.

Where to Start

Lay the cartons flat on the ground and open them carefully.

Open all the cartons, take the floor (bottom panel) from carton A firstly, start to install your

sauna pleasantly.

Tips: Before the start of installation, or at least before installation of the top panel, please

take out the accessories and screws etc.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wellis Serenis Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info