Bedienungsanleitung Westbo WeRa (Seite 4 von 7) (Englisch)

815061

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

Westbo WeRa Fire advise

Safety

Westbo WeRa is tested according to the DIN standard DIN

13240.

The stove is room air dependent, i.e., the combustion air is

consumed from the installation room. Make sure that an ade-

quate air supply is ensured.

The stove is equipped with a control for supply air to the com-

bustion and is located above the rebox.

Observe the distances to ammable objects. Do not leave

paper, newspapers or other combustible materials near the

stove.

The stove can be hot!

Risk of burns on all surfaces: combustion chamber door, door

and control handles, smoke pipes and the front of the stove.

Do not leave children unattended near the stove.

Empty the ashes

Never drain ash into a combustible vessel, preferably use a

sheet metal vessel with a tight tting lid. There may be ember

residues in the ashes several days after the end of the re.

Smell

At the rst ring, some odors may appear.

It is due to certain coatings on the plate that are burned off.

The smell disappears after a couple of bonres.

First re

We advise you to use ignition pads or equivalent. With

the help of these, there will be a quick over ignition of the

wood and a cleaner combustion.

Never use lighter uid.

At rst ignition, the supply air control shall be fully opened.

Put in about 1-2 kilograms of kindling wood (thin logs).

Put a 2-3 kindling pads on top and light on. Close the

door when the re has started. With this method, there

will be a quick over ignition and it minimizes soot coating

on the glass.

When lling wood, carefully open the door so that smoke

rash is avoided. Never ll up with wood as long as it burns

a lot.

Continuous ring

It is important to get the right temperature in the replace.

Then the stove and wood are utilized to the maximum

and there will be a clean combustion. Soot coating in the

rebox and on the glass is also avoided.

When red correctly, the smoke should not be visible, but

only perceived as a dripping in the air.

In the case of a good ember bed after the ignition pha-

se, the actual ring can begin with the right amount of

rewood.

Now adjust the supply air control relative to the draught

in the chimney. It should burn well, if it is strangled too

much, there is a risk of soot coating in the rebox, as well

as sooting on the glass.

Recommend amount of wood

We recommend smaller wood logs, that can be placed in

the stove. Length of wood is approximately 20 cm and at

the most 3 kg. The maximum amount of wood allowed is

approximately 3 kg per hour for dry cut birch wood.

Sweeping

Sweeping should be done by the Chimney sweeper.

Sweeping of the stove can be done by scraping down

and/or brushing. To collect the ashes, the most suitable

is to use a soot vacuum cleaner.

Chimney re

If a chimney re occurs or is feared, dampers and hatches

must be closed. If necessary, contact emergency services

for extinguishing. After a chimney re, the chimney must

always be inspected.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Westbo WeRa Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info